Siemens SINUMERIK 840D Series Diagnostics Manual

Also see for SINUMERIK 810D: Programming manual Programming manual Programming manual Function manual Function manual

1-401 Siemens AG, 2002. All rights reservedSINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition11.02 1 AlarmsReactions: - Alarm display.- Interface signals are set.- NC Start disable in this channel.- Interpreter stopRemedy: -Program Continuation: Clear alarm with the RESET key. Restart part program61602 Channel %1 block %2 tool width incorrectly definedParameters: %1 = Channel number%2 = Block number, labelDefinitions: Plunge cutter is larger than the programmed groove width. Alarm triggered by followingcycle: CYCLE93.Reactions: - Alarm display.- Interface signals are set.- NC Start disable in this channel.- Interpreter stopRemedy: -Program Continuation: Clear alarm with the RESET key. Restart part program61603 Channel %1 block %2 groove form incorrectly definedParameters: %1 = Channel number%2 = Block number, labelDefinitions: Radii/chamfers at the groove base do not match the groove width. Face groove on a con-tour element running parallel to the longitudinal axis is not possible. Alarm triggered byfollowing cycle: CYCLE93.Reactions: - Alarm display.- Interface signals are set.- NC Start disable in this channel.- Interpreter stopRemedy: -Program Continuation: Clear alarm with the RESET key. Restart part program61604 Channel %1 block %2 active tool violates programmed contourParameters: %1 = Channel number%2 = Block number, labelDefinitions: Contour violation in the relief cut elements due to the tool clearance angle of the toolused. Alarm triggered by following cycle: CYCLE95.Reactions: - Alarm display.- Interface signals are set.- NC Start disable in this channel.- Interpreter stopRemedy: Use a different tool or check the contour subroutine.Program Continuation: Clear alarm with the RESET key. Restart part program61605 Channel %1 block %2 contour incorrectly programmedParameters: %1 = Channel number%2 = Block number, labelDefinitions: Illegal relief cut element detected. Alarm triggered by following cycles: CYCLE76,CYCLE77, CYCLE95.