Siemens SINUMERIK 840D Series Diagnostics Manual

Also see for SINUMERIK 810D: Programming manual Programming manual Programming manual Function manual Function manual

1-219 Siemens AG, 2002. All rights reservedSINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition11.02 1 AlarmsRemedy: Correct the part program and add the axis address or the traversing path to the measure-ments block.Program Continuation: Clear alarm with NC START or RESET key and continue the program.16000 Channel %1 block %2 invalid value for lifting directionParameters: %1 = Channel number%2 = Block number, labelDefinitions: During the "rapid lift from contour" (keyword: LIFTFAST), a code value for the lifting direc-tion (keyword: ALF=...) which lies outside the permissible range (permissible value range:0 to 8) was programmed .With active cutter radius compensation:Code numbers 2, 3 and 4 cannot be used in G41Code numbers 6, 7 and 8 cannot be used in G42 because they code the direction to thecontour.Reactions: - Alarm display.- Interface signals are set.- Correction block is reorganized.Remedy: Program the lifting direction under ALF=... within the permissible limits.Program Continuation: Clear alarm with NC START or RESET key and continue the program.16005 Channel %1 block %2 invalid value for lifting distanceParameters: %1 = Channel number%2 = Block number, labelDefinitions: Mistake in programming: the value for the lifting path must not be negative.Reactions: - Alarm display.- Interface signals are set.- Correction block is reorganized.Remedy: Modify part program.Program Continuation: Clear alarm with NC START or RESET key and continue the program.16010 Channel %1 block %2 machining stop after lift fastParameters: %1 = Channel number%2 = Block number, labelDefinitions: LIFTFAST without interrupt routine (Asup) has been programmed. The channel isstopped after the lift motion has been carried out.Reactions: - Alarm display.- Interface signals are set.- Interpreter stop- NC Start disable in this channel.Remedy: After the channel stop, the axes must be retracted manually in JOG and the programaborted with Reset.Program Continuation: Clear alarm with the RESET key. Restart part program16015 Channel %1 block %2 wrong axis identifier %3Parameters: %1 = Channel number%2 = Block number, label%3 = Axis nameDefinitions: Axis names from different coordinate systems were used to program axes for LIFTFAST.The retraction movement is no longer clear.