Remove an analog input/output module as follows:Step Action1 Release the upper locking bar on the subrack and swivel itupwards and out.2 Slacken the screw in the upper part of the front connector.This causes the front connector to be pressed out of thefemale connector of the module.Contacts F+ and F- of the enable input at the upper end ofthe front connector are thus opened first. If the enable inputis active, power is removed from the outputs and the moduleis isolated from the S5 bus.3 Swing the front connector out and lift it away from thesupport pin of the module.4 Release the module by rotating the locking pin by 90o at thelower end of the module. You can pull the module out of thesubrack with a grip with swivels outwards.1 Screw2 Locking pin3 Support mount4 Support pin5 Grip6 Backplane connectorComply with VDE Specifications 0110 and 0160 to carry out thewiring of supply and signal lines which are to be connected to theprogrammable controllers and front connectors of the modules.Detailed information on cabinet assembly, cabinet ventilation andprotective measures can be found in Chapter 3.123564ModuleFrontConnectorSupport MountSupport PinFigure 9-4 Module with Front ConnectorThe 460 Analog Input ModuleSystem Manual9 - 16 C79000-B8576-C109-03
