MC55_ATC_V04.00 Page 133 of 475 3/17/06Confidential / Released7.6 ATD> Mobile originated call from active memory using cor-responding fieldSyntaxCommand DescriptionThis command searches the active phonebook for a given string and dials the assigned phone number.The termination character ";" is mandatory since dialing from a phonebook is only supported for voice calls andfor sending *# codes of Supplementary Services or other functions.Parameter DescriptionString type value ("x"), which should equal an alphanumeric field in at least one phonebook entry in the searchedmemories; used character set should be the one selected with AT+CSCS. can contain escape sequencesas described in chapter "Supported character sets". must be wrapped in quotation marks (""), if escape sequences or parameter are used or if thealphanumeric strings contains a blank. If not, quotation marks are optional.If AT+CSCS is set to "UCS2", with respect to the coding of UCS2-characters only phonebook entries that containan alphanumeric string with as size less than the half of the parameter from AT+CPBW can bedialed.String of GSM modifiers:I Activates CLIR (disables presentation of own phone number to called party)i Deactivates CLIR (enables presentation of own phone number to called party)Notes• This command may be aborted generally by receiving a character during execution. Abortion is not possibleduring some states of connection setup such as handshaking.• The command is not applicable to data calls. Any attempt to dial without semicolon ";" causes theresult code "NO CARRIER" to appear.• Parameter only if no *# code is within the dialing string.Exec CommandATD>[];Response(s)ERROR+CME ERROR: If no dialtone (parameter ATX2 or ATX4):NO DIALTONEIf busy (parameter setting ATX3 or ATX4):BUSYIf connection cannot be set up:NO CARRIERWhen TA returns to command mode after call release:OKIf successfully connected:OKReference(s) PIN ASC0 ASC1 MUX1 MUX2 MUX3 Charge LastV.250 % % § % § § ! ! !(str)(+CSCS)(str)
