Sealey LED3009 Instruction Manual

Thank you for purchasing a Sealey product. Manufactured to a high standard this product will, if used according to these instructions and properly main-tained, give you years of trouble free performance.IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS &CAUTIONS. USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SOMAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. PLEASE KEEP INSTRUCTIONS SAFEFOR FUTURE USE.1. SAFETY1.1. GENERAL Ensure the lamp is fully charged before initial use. DO NOT turn the lamp on when it is being charged. DO NOT shine directly into your, other person’s oranimal’s eyes. DO NOT allow children to use the lamp. DO NOT handle or move the lamp whilst it is beingcharged. DO NOT use the lamp if you suspect that the battery orthe lamp casing is damaged. DO NOT leave battery in a discharged state, rechargebattery immediately. Before storage, fully recharge thebattery, subsequently recharge the battery at least onceevery three months of non-use.1.2. ELECTRICAL SAFETY FOR USE OF CHARGER.USE ONLY THE SUPPLIED CHARGER. WARNING! It is the user’s responsibility to read,understand and comply with the following electricalinstructions:You must ensure the risk of electric shock is minimisedby the installation of appropriate safety devices.An RCCB (Residual Current Circuit Breaker) should beincorporated in the main distribution board. We alsorecommend that an RCD (Residual Current Device) isused with all electrical products, particularly portableequipment which is plugged into an electrical supply notprotected by an RCCB.You must also read and understand the following instructionsconcerning electrical safety.1.2.1. The Electricity At Work Act 1989requires all portable electrical appliances, if used onbusiness premises, to be tested by a qualified electrician,using a Portable Appliance Tester (PAT), at least once ayear.1.2.2. The Health & Safety at Work Act 1974 makes ownersof electrical appliances responsible for the safe conditionof the appliance and the safety of the appliance operator.If in any doubt about electrical safety, contact aqualified electrician.1.2.3. You must ensure that you: Inspect the charger plug, cable and connector for wearand damage to ensure items are safe before connectingto the mains power supply.If worn or damaged DO NOT use. Important: Check that the voltage marked on the chargeris the same as the power supply to be used. DO NOT pull the charger plug from the mains socket bythe lead. WARNING! DO NOT use any other type of charger withthis product, other than the supplied mains charger.Failure to observe this warning could result ininjury and or fire and will invalidate the warranty. DO NOT try to take the charger apart. DO NOT get the charger wet, or use in wet, dampconditions (for indoor use only).1.2.4. Ensure that the insulation on all cables and on theappliance is safe before connecting it to the powersupply. See 1.2.1. and 1.2.2. and use a PortableAppliance Tester.1.2.5. Ensure that cables are always protected against shortcircuit and overload.1.2.6. DO NOT use worn or damaged cables, plugs orconnectors. Immediately have any faultyitem repaired or replaced by a qualified electrician.When a BS 1363/A UK 3 pin plug is damaged, cut thecable just above the plug and dispose of the plug safely.Fit a new plug according to the following instructions (UKonly).a) Connect the GREEN/YELLOW earth wire to theearth terminal ‘E’.b) Connect the BROWN live wire to the live terminal ‘L’.c) Connect the BLUE neutral wire to the neutralterminal ‘N’.d) After wiring, check that there are no bare wires, thatall wires have been correctly connected, that thecable outer insulation extends beyond the cablerestraint and that the restraint is tight.Double insulated products, which are always markedwith this symbol , are fitted with live (brown) andneutral (blue) wires only. To rewire, connect the wires asindicated below.DO NOT connect either wire to the earth terminal.1.3 Battery Safety WARNING! To reduce the risk of burns or fire: DO NOT Attempt to open, disassemble, modify orservice the battery pack. DO NOT Crush, puncture, short external contacts ordispose of in fire or water. DO NOT Expose to temperatures above 60°C (140°F). Replace only with the battery pack designated for thisproduct. Recycle or dispose of used battery as stipulated by localregulation. If the electrolyte in the cells gets on your skin, thoroughlywash with soap and water. If it gets in your eyes, rinsethoroughly with cool water and seek immediate medicalattentionFUSE RATING3 AMPBlueNeutralWireYellow & GreenEarth WireCableRestraintBrownLiveWireINSTRUCTION MANUAL FOR:CORDLESS 30 + 5LED RECHARGEABLEINSPECTION LAMPMODEL No. LED3009Original Language Version LED3009 Issue: 2 - 15/03/10

/ 2

Related manuals for Sealey LED3009