Menu
Samsung WA50K8600A Series User Manual
Also see for WA50K8600A Series: User manual
                                                                                                                                                                                                                  |
English 27InstallationSTEP 6 Running a test cycleRun a test cycle as follows to check if your washer is properly installed.1. Load about 6 pounds of laundry into the tub.2. Press Power to turn on your washer.3. Select Rinse+Spin by press the Cycle Selector.4. Press and hold Start/Pause to start the test cycle.5. The washer should not rock or vibrate excessively when water is supplied or whenwashing or spinning, and should drain well during the spin cycle.NOTEIf water leaks while water is being supplied or drained, check the water connections. Refer tothe “STEP 2 Connecting the water supply hose” section on page 21 for instructions.NOTEIf the washer rocks and vibrates excessively, level your washer again. Refer to the “STEP4 Leveling your washer” section on page 25 for instructions.STEP 7 Calibration ModeYour Samsung washer detects the laundry weight automatically.For more accurate weight detection, please run Calibration Mode after the installation.To run Calibration Mode, follow these steps:1. Remove laundry or any contents in the machine.2. Press and hold Temp. and Delay End simultaneously for at least 3 seconds when thepower is turned on.3. Press and hold Start/Pause to activate Calibration Mode.4. The pulsator rotates clockwise and counterclockwise approximately 1 minute.5. When Calibration Mode is finished, “0” appears on the display, and the washerautomatically turns off. The washer is now ready for use. |
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved