Wireless network setup1782. Using a Network-Connected Machine- SSID Type: After completing the wireless networkconnection process, the AP’s SSID information appears onthe display.• For models without a display screen, follow the steps below:a Press and hold the (WPS) button on the control panel forabout 2 - 4 seconds until the status LED blinks quickly.The machine starts connecting to the wireless network. The LEDblinks slowly for up to two minutes until you press the PBCbutton on the access point (or wireless router).b Press the WPS (PBC) button on the access point (or wirelessrouter).- The light blinks fast on the WPS LED. The machine isconnecting to the access point (or wireless router).- When the machine is successfully connected to the wirelessnetwork, the WPS LED light stays on.13 Wireless network set up is completed. After installation is finished, clickQuit.After completing the wireless network connection, you need to install amachine driver to print from an application (see "Installation for Macintosh"on page 134).Ad hoc via USB cableIf you do not have an access point (AP), you may still connect the machinewirelessly to your computer by setting up an ad hoc wireless network byfollowing these simple directions.Items to prepare• Network-connected computer• Software CD that was provided with your machine• A machine installed with a wireless network interface• USB cableCreating the ad hoc network in Macintosh1 Check whether the USB cable is connected to the machine.2 Turn on your computer and the wireless network machine.3 Insert the supplied software CD into your CD-ROM drive.4 Double-click the CD-ROM icon that appears on your Macintosh desktop.5 Double-click the MAC_Installer folder > Installer OS X icon.6 Click Continue.7 Read the license agreement and click Continue.
