137Multi ControlMENU m → System → Multi Control → ENTEREMulti ControlID SetupID InputMDC ConnectionDisplayPort Daisy Chain00--RS232C MDCClone- The displayed image may differ depending on the model.Configuring settings for Multi Control• ID SetupAssign an ID to a set. (Range: 0~99)Press or to select a number, and press E.• ID InputEnter the ID number of the product connected to the input cable for input signal reception.Enter the number you want using the number buttons on the remote control.• MDC ConnectionSelect a method to connect to MDC to receive the MDC signal.- RS232C MDC: Communicate with MDC via the RS232C-stereo cable.- RJ45 MDC: Communicate with MDC via the RJ45 cable.• DisplayPort Daisy ChainTo display the DP IN video input through the DP OUT output port, select a device connection method from SingleStream Transport (SST) and Multi Stream Transport (MST).Clone: In this Single Stream Transport (SST) output mode, the same screen output is displayed on two display devicesconnected.― If Clone is selected, the PC recognizes the two displays as a single monitor.― Clone mode is enabled if the input source is a digital input other than DisplayPort, such as DVI, HDMI1, HDMI2,HDMI3.Expand: In this Multi Stream Transport (MST) mode, a different screen output is displayed on two display devicesconnected.― If Expand is selected, the PC recognizes the two displays as separate monitors.― The mode functions only on a PC that supports DisplayPort 1.2 MST.― For Full HD resolution (1920x1080) displays, a maximum of four displays can be connected.