Samsung HT-H4500K User Manual

Also see for HT-H4500K: User manual

17 - EnglishSettingsSupportSoftware UpgradeFor more information about this function see page18.Contact SamsungProvides contact information for assistance withyour product.Terms of Service AgreementView the general disclaimer regarding third partycontents and services.ResetReverts all settings to their defaults except for thenetwork. Requires that you enter your security PIN.The default security PIN is 0000.Network SetupWhen you connect this product to a network, youcan use network based applications and functionssuch as BD-LIVE and upgrade the product's softwarethrough the network connection.Configuring Your Network ConnectionIf you skipped network setup during the Initial Setup,follow the instructions below to configure the homecinema's network connection.Before you begin, contact your ISP to find out if yourIP address is static or dynamic. If it is dynamic, werecommend you use the automatic procedure below.If it is static, you must use the manual procedure thatfollows.• Before you begin, confirm that the product isconnected to your router with a network cable. AutomaticTo start the configuration process, follow these steps:1. In the Home menu, select Settings, and thenpress the E button.2. Select Network, and then press the E button.3. Select Wired Network Settings, and then pressthe E button.The Wired Network Settings screen appears.4. Press the + button on the Internet ProtocolSetup menu.Use % button to select Auto, and then pressthe E button.SettingsDisplayAudioNetworkSystemLanguageSecurityGeneralSupport0 0 0 000 0 0 00 0 0 00 0 0Wired Network SettingsInternet Protocol Setup : AutoIP Address :Subnet Mask :Gateway :DNS : AutoDNS Server :> Move " Select ' Return5. The Network function acquires and fills in thevalues for IP Address, Subnet Mask, etc.,automatically.6. After the Network function has acquired thenetwork values, press the RETURN button.7. Select Network Test, and then press E. Thehome cinema validates the network connection.When it is done, press the RETURN button. ManualIf you have a static IP address or the Automaticprocedure does not work, you’ll need to set the NetworkSettings values manually. You can get the NetworkSettings from your Internet Service Provider (ISP).SettingsDisplayAudioNetworkSystemLanguageSecurityGeneralSupport0 0 0 0255 255 255 00 0 0 00 0 0 0Wired Network SettingsInternet Protocol Setup : ManualIP Address :Subnet Mask :Gateway :DNS : ManualDNS Server :> Move " Select ' Return1. Follow the first four steps in the Automaticprocedure, but select Manual instead of Auto inStep 4.