Samsung HT-F5500K User Manual

Also see for HT-F5500K: User manual User manual

| 26 EnglishSettings3. Select the IP setting field, and then set it to Entermanually.4. Select a value to enter (IP Address, for example),and then press E. Use the number keypad onyour remote control to enter the numbers for thevalue. You can also enter numbers using the ▲▼buttons. Use the ◄► buttons on the remote controlto move from entry field to entry field within a value.When done with one value, press the E button.5. Press the ▲ or ▼ button to move to another value,and then enter the numbers for that value followingthe instructions in Step 4.6. Repeat Steps 4 and 5 until you have filled in allvalues.| NOTES | You can get the Network values from your Internetprovider.7. When finished entering all the values, select OK,and then press the E button. The home cinemaverifies the network connection and then connectsto the network.Wireless NetworkYou can setup a wireless network connection in threeways:- Wireless Automatic- Wireless Manual- WPS(PBC)Before you configure the wireless network connection,disconnect any wireless network device currentlyconnected to the product or, if applicable, the product'scurrent wired connection. Wireless - AutomaticAfter following Steps 1 to 3 in "Configuring Your NetworkConnection" on page 25:1. In the Network Settings screen, change Networktype to Wireless. The product searches for andthen displays a list of the available networks.Network SettingsSelect your network type.Network type WirelessWireless networkYou can connect your Blu-rayplayer to the internet. Pleaseselect which wireless network touse.si-apiptimeiptime5GKIMING_VTOWERTIASRefresh WPS(PBC)2. Select the desired network, and then press the Ebutton.3. On the Security screen, enter your network'ssecurity code or pass phrase.Enter numbers directly using the number buttonson your remote control. Enter letters by selecting aletter with ▲▼◄► buttons, and then pressing Ebutton.4. When finished, select the Done, and then pressthe E button. The product verifies the networkconnection and then connects to the network.| NOTES | You should be able to find the security code or passphrase on one of the set up screens you used to setup your router or modem. Wireless - ManualIf you have a static IP address or the Automaticprocedure does not work, you'll need to set the NetworkSettings values manually.After following Steps 1 to 3 in "Configuring Your NetworkConnection" on page 25:1. In the Network Settings screen, change Networktype to Wireless. The product searches for andthen displays a list of the available networks.2. Scroll through the list, select the desired network orAdd Network, and then press the E button.3. If you selected a network in Step 2, go to Step 6.If you selected Add Network, go to Step 4.4. Enter your wireless network or wireless router'sname.• Enter numbers directly using the number buttonson your remote control.• Enter letters by selecting a letter with the ▲▼◄►buttons, and then pressing the E button.• To display capital letters (or redisplay small lettersif capital letters are displayed), select , andthen press the E button.• To display symbols and punctuation, select123#&, and then press the E button. Toredisplay letters, select 123#&, and then pressthe E button.When finished, select Done, and then press the Ebutton.