《18》Down button■ While the menu is showing, press the DOWN button to move from the mainmenu to a sub menu, or to move down the sub menu cursor.■ Unless the menu is showing, the DOWN button will not work in a Recordingmode.Flash ( )/ Left buttonFocus type Flash rangeAuto 1.0m~3mMacro 0.2m[Selecting the Auto flash]● Flash range (Unit : m)■When the menu is displayed on the LCD monitor,pressing the LEFT button makes the cursor shift tothe left tab.■When the menu is not displayed on the LCD monitor,the LEFT button operates as the FLASH ( ) button.●Selecting the flash mode1. Press the M (Mode) button to select a Recordingmode with the exception of Movie clip mode (p.22).2. Press the Flash button until the desired flash mode indicator displays on theLCD monitor.3. A flash mode indicator will be displayed on the LCD monitor.Use the correct flash to suit the picture taking situation.Voice recording( )/ Voice memo( )/ UP button■ While the menu is showing, press the UP button to move up the sub menucursor. When the menu is not displayed on the LCD monitor, the UP buttonoperates as the voice recording or voice memo button. You can record yourvoice or add your voice-over to a stored still image. Refer to page 15 for moreinformation about the voice recording.● Recording a voice memo1. Select the STILL IMAGE mode by pressing the mode button.2. Press the VOICE MEMO( ) button. If the voice memo indicator is displayedon the LCD monitor, the setting is completed.3. Press the shutter button and take a picture. The picture is stored on thememory card.4. Voice memo will be recorded for ten seconds from the moment the picture isstored. In the middle of the sound recording, pressing the shutter button willstop the voice memo.※A distance of 40cm between you and the camera (microphone) is the bestdistance to record sound.[ Preparing for Voice Memo ] [ Recording Voice Memo ]