Samsung 5 Series Installation Manual

Also see for 5 Series: Quick setup guide Quick setup guide Quick setup guide Quick start guide User manual

8EnglishConnecting a Pillow SpeakerYou can connect a pillow speaker to the TV in the hospital using a jumper cable. The speaker functions as a remote controland speaker.1. Connect the pillow speaker jumper cable (cable sold separately) from the television's PILLOW SPEAKER Port to thepillow speaker jack on the wall behind the television.Pillow Speaker Jack Specificationsy Output jack: RCA typey Input jumper pin: 1/8" 3-conductor stereo phone pin.y Signal specifications: Tip-Audio, Ring-Data/Channel change, Sleeve-CommonTip Ring SleeveVOL +VOL -123How to Use the Pillow Speakery Analog type speaker: The pillow speaker has one key.– Power On: press the key when the TV is in standby mode.– Channel Up: press the key when the speaker is on.– Power Off: press and hold the key for more than 3 seconds when the speaker is on.– An Analog type speaker always works regardless of the Pillow Speaker Type value set in the Hospital mode setupmenu.y Digital type speaker: The TV supports the Samsung, Philips, or Zenith code.– This speaker is only compatible with a specified IR code. You can change the code in the Hospital mode setup menu.– The TV gives priority to the Samsung remote control over the pillow speaker's wired remote control.– Option : Channel Menu Display.Pillow Sound ControlSpeaker Selection Menu TV Speaker Pillow SpeakerTV Speaker Sound SoundExternal Speaker No Sound Soundy Anynet+ function is not supported in hospital models.TV Rear PanelJumper CablePillow Speaker