53INSTALLATION AND ASSEMBLY[Fig. 3-4-19][3] Fix the cabinets using bolts. [Fig. 3-4-2]Front: M8x30 x 2 (provided with each stand)Rear: M8x60 x 2 (provided with each stand)[4] Align the left and right cabinets. If the following conditions are not satisfied, adjust using the adjusters onthe stands.(Front/rear): Line up the wood surfaces of the front of the left and right cabinets. [Fig. 3-4-3](Top/bottom): Align the height of the bottom plates on the front of the left and right cabinets. [Fig. 3-4-4](Inclination): Reduce any clearance between the left and right cabinets to below 3 mm. [Fig. 3-4-5]FlushLeft/right symmetrical2 9-screen system assembly (using the RMA-V5020/WL)— Please refer to the section on 4-screen system assembly for cautionary notes.—[1] Place the cabinet on each stand. (3 cabinets)NOTE) Always carry each cabinet with more than one person.[2] Adjust the positioning of the cabinets. [Fig. 3-4-19]Align the front and rear of each cabinet/stand with respect to the L-shaped brackets on the stand.Align the left and right of each cabinet/stand so as to make flush the side surfaces of the cabinet/stand on theside which comes in contact with another cabinet/stand pair.Place the central cabinet/stand in a symmetrical position with respect to the other pairs of cabinet/stand.Bolts (M8x30) Flush
