| 
126ADJUSTMENTS[4] (GET W/B DATA) — White balance adjustment data is output.Format : Output in the following order.1 STX (02H)2 / LINEAR WHITE adjustment data (3 BYTE)3 /CONTRAST adjustment data (3 BYTE)4 /BRIGHTNESS adjustment data (3 BYTE)5 /COLOR adjustment data (3 BYTE)(Note 1)6 /TINT adjustment data (3 BYTE)(Note 1) and(Note 3)7 /BLUE LOW-LIGHT adjustment data (3 BYTE)8 /GREEN LOW-LIGHT adjustment data (3 BYTE)9 /RED LOW-LIGHT adjustment data (3 BYTE)0 /BLUE HIGH-LIGHT adjustment data (3 BYTE)- /GREEN HIGH-LIGHT adjustment data (3 BYTE)= /RED HIGH-LIGHT adjustment data (3 BYTE)~ /SHARPNESS adjustment data (3 BYTE)(Note 1) and(Note 5)! /ABL LEVEL adjustment data (3 BYTE)(Note 4)@ /ABL GAIN adjustment data (3 BYTE)(Note 2)# ETX (03H)(Note 1) Dummy when INPUT=RGB(Note 2) No dependent on mode. (Has one data.)(Note 3) Dummy when PAL signal is input. (INPUT=VIDEO or Y/C)(Note 4) Dummy when COMBINATION=OFF (Data is output when COMBINATION=ON)(Note 5) SHARPNESS data for OFF is output when MULTI=OFF, and SHARPNESS data for ON is output whenMULTI=ON.[5] GVO (GET ABL VOLTAGE) — The ABL voltage is converted within the range of 0 to 5V, identified in 256 stepsand output. (3 BYTE)[6] (GET CONV. USER DATA) — Deflection and convergence data memory area setting state is output.1 STX (02H)2 Memory area selected when INPUT=VIDEO or Y/C & input signal=NTSC. (3 BYTE)Example)US 1:Indicates CONV.MEMO-1 is selected.3 Memory area selected when INPUT=VIDEO or Y/C & input signal=PAL(Or other than NTSC, containing no signals). (3 BYTE)Example)US 2:Indicates CONV.MEMO-2 is selected.4 Memory area selected when INPUT=RGB & input signal=NTSC. (3 BYTE)Example)US 1:Indicates CONV.MEMO-1 is selected.5 Memory area selected when INPUT=RGB & input signal=PAL(Or other than NTSC, containing no signals). (3 BYTE)Example)US 2:Indicates CONV.MEMO-2 is selected.6 IETX (03H) |
