Pioneer RM-V2550 Manual 

Also see for RMD-V3104U: Operating instructions

Contents

11GENERAL SPECIFICATIONSNo. Name Type Function1 ABL linking switch Slide switch When ABL linking is on, the ABL linking controlvoltage’s control quantity can be switched2 Linked input terminal DIN 6-pin ABL, remote control signal and RS-232C signal inputterminal3 Linked output terminal DIN 6-pin ABL, remote control signal and RS-232C signal outputterminal4 Remote control connector Mini jack Jack for connecting adjustment remote control unit(sold separately)5 RS-232C port D-sub 25-pin RS-232C communications connector(female)6 Control input terminal BNC connector Video input and Y/C input external switching controlsignal input terminal7 Y (brightness) BNC connector Brightness signal input terminalinput terminal8 C (color) input terminal BNC connector Color signal input terminal9 Video input terminal BNC connector Video signal input terminal0 Video output terminal BNC connector Video input terminal 9 through out terminal- Terminating switch Slide switch Turn on to terminate video input terminal 9 at 75 ohm= Input selector switch Tact switch Video input, Y/C input, RGB input selector switch.At the VIDEO position, switching between the videoinput and Y/C input is possible with the external controlsignal 6.~ POWER switch Tact switch When power off: STANDBY (red LED) lightsWhen power on: ON (green LED) lights! STATUS indicator switch Tact switch Switch for displaying the total power on time (*), switchsettings, etc., on the screen@ RGB input terminal D-sub 9-pin (male) RGB signal input terminal# RBG input selector switch Slide switch Switch for selecting the RGB signal input terminalformat$ RGB input terminal BNC connector RGB signal vertical synchronization input terminal(vertical synchronization)% RGB input terminal BNC connector RGB signal horizontal synchronization and composite(horizontal synchronization synchronization (for only input signal H/V synchronization)/composite synchronization) input terminal^ RGB input terminal (B) BNC connector RGB signal B input terminal& RBG input terminal BNC connector RGB signal G or G on Sync input terminal(G/G on Sync)* RBG input terminal (R) BNC connector RGB signal R input terminal¶ Turn the power off with the POWER switch ~ on the set, through RS-232C control or with the wired remotecontrol unit (sold separately). (If the power supply is interrupted with the main power switch or if the powercable is disconnected from the outlet, the switch settings in ! above, the TV system and the convergencememory settings will not be stored in the last memory.)Thus, for permanent installations, to start up and stop the entire system by turning the AC power on and off,the power must first be turned off as described above in order to store the settings in the last memory.(Refer to “Chapter 4, 2 (5) Last memory of adjustment data and settings “.)* Total power on timeOnly counted when power is set to ON.