Pioneer Elite PRO-1120HD Operating Instructions Manual

Also see for Elite PRO-1120HD: Correction Operating Instructions Operating instructions

Contents

09 Tuner Setup32EnNaming TV channelsYou can name TV channels that you have set up for antenna B.This may help you easily identify the channels during selections.1 Press HOME MENU.2 Select “Tuner Setup”. ( / then ENTER)3 Select “Channel Setup”. ( / then ENTER)4 Select “Ant. B”. ( / then ENTER)5 Select “Name Channel”. ( / then ENTER)6 Select a channel. ( / then ENTER)• You can also use buttons 0 – 9 to enter a channelnumber.Channel Setup Ant. B Name ChannelAnt. B Name ChannelxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxExitHome Menu7 Enter up to 7 alphanumeric characters using / ,/ , and ENTER.• To clear the last character, press B.Channel SetupCancelAnt. B Name ChannelA B C D E F G H I JK L M N O P Q R S TU V W X Y Z 1 2 3 45 6 7 8 9 0 . @ / () , – _ : ' & S P A C EName: DTV2Ant. B Name ChannelxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxClearAccept ExitHome MenuDBA8 Press A.9 Press HOME MENU to exit the menu.Checking signal strengthWhen you have selected antenna A, you can check the currentchannel’s signal strength. You may use this function whenreceiving a channel through a VHF/UHF antenna.1 Press HOME MENU.2 Select “Tuner Setup”. ( / then ENTER)3 Select “Channel Setup”. ( / then ENTER)4 Select “Ant. A”. ( / then ENTER)5 Select “Signal Strength”. ( / then ENTER)Channel SetupExitAnt. A Signal StrengthAnt. A Current: 100Maximum: 100 xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxHome MenuSignal Strength• Adjust the direction of the antenna so that the currentsignal strength reaches as close to the maximum signalstrength as possible.6 Press HOME MENU to exit the menu.Checking the Cable Card IDThe Media Receiver has a slot for a cable card that is used formanaging your information by the cable TV company. Thefollowing procedure allows you to check your Cable Card ID andthe Host ID.1 Press HOME MENU.2 Select “Tuner Setup”. ( / then ENTER)3 Select “Channel Setup”. ( / then ENTER)4 Select “POD ID”. ( / )• The Host ID and Cable Card ID appear.5 Press HOME MENU to exit the menu.Enabling data acquisitionUse this function to enable the system to automatically acquireinformation about digital TV programs even when in the standbymode.1 Press HOME MENU.2 Select “Tuner Setup”. ( / then ENTER)3 Select “Channel Setup”. ( / then ENTER)4 Select “Data Acqu”. ( / then ENTER)5 Select “Enabled”. ( / then ENTER)6 Press HOME MENU to exit the menu.• The DATA ACQUISITION indicator on the front of the MediaReceiver lights while data is being acquired.