Panasonic th-49lf8w Operating Instructions Manual

Contents

Panasonic th-49lf8w Operating Instructions Manual Manual pdf 70 page image

English70● Panasonic has tested other manufacturers’ devicesaccording to our check items. This will not guaranteeall the opera ions. For operation and performancedefects caused by other manufacturers’ devices,contact each manufacturer.Command controlNetwork function of the unit can control the unit in thesame way as serial control from a network.Supported commandsCommands used in the serial control are supported.(see page 21)Control Command via LANThe communication differs whether [Op ions] - [LANcontrol protocol] is set to [Protocol 1] or [Protocol 2].1. When [LAN control protocol] is setto [Protocol 1].Communicates using the display-specific protocol.■ When the WEB control administratorprivileges password has been set (Protectmode)Connection method1 Obtain the display’s IP address and the port number(Default is 1024), and request connection to thedisplay.The IP address and the port number can be obtainedfrom the following menus.• IP address:[Setup] → [Network settings] → [LAN setup] or[Network status]• Port number:[Setup] → [Network settings] → [LAN setup]For more detail of the settings, see page 52, 52.2 The display responds.Response dataData part Space Mode SpaceRandomnumberpartLastterminalsymbol[PDPCONTROL](ASCIIcharacterstring)[ ]0x20[1]0x31[ ]0x20[zzzzzzzz](ASCIIcode hexnumber)(CR)0x0d10 bytes 1 byte 1 byte 1 byte 8 bytes 1 byteMode:1 = Protect mode3 Hash the following data with the MD5 algorithm, andgenerate a 32-byte hash value.[zzzzzzzzyyyyy]zzzzzzzz :8-byte random number obtained in step 2yyyyy :WEB control administrator privileges user● Default user name and password are as follows:User name: admin1Password: panasonicCommand transmission methodTransmit in the following command formatTransmitted dataHeader Controlsymbol Data part ControlsymbolLastterminalsymbolHash value(see“Connectionmethod”)(STX)0x02Controlcommand(ASCIIcharacterstring)(ETX)0x03(CR)0x0d32 bytes 1 byte Undefined 1 byte 1 byteReceived dataControlsymbol Data part ControlsymbolLast terminalsymbol(STX)0x02Controlcommand(ASCIIcharacterstring)(ETX)0x03(CR)0x0d1 byte Undefined 1 byte 1 byteError responseError messageLastterminalsymbol“ERR1” : Undefined controlcommand(CR)0x0d“ERR2” : Out of parameterrange“ERR3” : Busy status orreception invalidperiod“ERR4” : Timeout or receptioninvalid period“ERR5” : Wrong data length“PDPCONTROLERRA”: Mismatching ofpassword4 bytes or 15 bytes 1 byte