Panasonic th-49lf8w Operating Instructions Manual

Contents

Panasonic th-49lf8w Operating Instructions Manual Manual pdf 52 page image

English52■ [Network control]Set when controlling with the unit’s LAN terminal.[On]:Controls via LAN using the LAN terminal of heDisplay. The power indicator lights orange whenhe power is turned off with the remote control(standby).[Off]:Invalidates control with LAN terminal.(In this case, the power consumption of Standbycondition (when the power is turned off with theremote control) will be slightly reduced.)Note● When using the LAN control function for “UsingNetwork Function” (page 68 - 75), set this functionto [On]. Even if [Off] is selected, the HDMIcommunication via a twisted pair cable transmitteris possible while the power is on.■ [Display name]The name of the Display that is shown on the networkcan be changed.■ [LAN setup]Detailed network settings for the LAN established viahe LAN terminal of the Display or twisted pair cabletransmitter can be configured.Select [LAN setup] wi h and press .192.168. 0. 8255.255.255. 0192.168. 0. 11024--:--:--:--:--:--LAN setupSaveDHCP OffIP addressSubnet maskGatewayPortMAC address[DHCP], [IP address], [Subnet mask], [Gateway]Press to set [On] / [Off] of [DHCP] and press.When [Off] is selected, IP address and other settingscan be set manually.[DHCP]:(DHCP client func ion)[On]:Obtains an IP address automatically when aDHCP server exists in the network the Display isgoing to be connected.[Off]:When a DHCP server does not exist in thenetwork the Display is going to be connected,set [IP address], [Subnet mask] and [Gateway]manually.[IP address]:(IP address display and setting)Enter an IP address when DHCP server is not used.[Subnet mask]:(Subnet mask display and setting)Enter a Subnet mask when DHCP server is notused.[Gateway]:(Gateway address display and setting)Enter a gateway address when DHCP server is notused.Note● When [DHCP] is set to [On], the IP address, etc. willbe displayed in grey.Entering numbersI192. 168. 000. 008IP address1. Select the address and press .2. Select digits with .3. Change numbers with .4. Press .You can cancel the change by pressing.Select [Save] and press .Save the current network Setup.Note● To use a DHCP server, make sure the DHCPserver is started.● Contact your network administrator for details on[IP address], [Subnet mask] and [Gateway].● Shipping condition[DHCP]: Off[IP address]: 192.168.0 8[Subnet mask]: 255.255.255.0[Gateway]: 192.168.0.1[Port]Set the port number used for command control.Select [Port] and press to set the number.● The available setting range is 1024 - 65535.● Entering numbers (see page 52)Note● When the PJLink protocol is used, he port setting isnot necessary.[MAC address]Displays the MAC address of this unit.