Panasonic WV-NW502SE Installation Manual

Also see for WV-NW502SE: Operating instructions

Panasonic WV-NW502SE Installation Manual Manual pdf 26 page image

Note:• At the same time for the pan and tilt adjustments, make focus adjustments of Step 2.Important:• The panning lock and tilting lock screws shall be securely tightened.(Recommended tightening torque: 0.59 N·m)x Adjusts the focus.At the same time for the pan and tilt adjustments, make focus adjustments.Adjust the focus by following the adjust-ing procedure of q, w and e shownbelow.q Hold down the auto back focus but-ton for 5 sec. or more to set ABF tothe standard position.w Loosen the zoom lock lever andmove the lever between TELE andWIDE to obtain the appropriateangle of view.e Loosen the focus lock knob, rotatethe focus adjustment grip to adjustthe focus coarsely, and then tightenthe focus lock knob.26ABFINITIALSETMONITOROUTFocus lock knobFocusadjustment gripZoom lock knobAdjust the cameraz Be sure to view the monitor for adjust-ment when the camera angle is adjust-ed.Connect an adjusting monitor (such as asmall LCD monitor) to the monitor outconnector (for adjustment) and adjustthe camera angle.Turn on the power after connecting theadjusting monitor.Follow the steps q, w and e to adjustthe camera angle.q Loosen the panning lock screw,rotate the camera horizontally toadjust pan direction, and then tight-en the panning lock screw.w Loosen the tilting lock screw, rotatethe camera vertically to adjust tiltdirection, and then tighten the tiltinglock screw.e Rotate the tilt adjusting table to adjust the azimuth angle of the image.LOCKLOCKPanning lock screw75 °Tilt adjusting tableMonitor out connectorfor adjustmentTilting lock screwPanning table