Panasonic WV-NW502SE Installation Manual

Also see for WV-NW502SE: Operating instructions

Panasonic WV-NW502SE Installation Manual Manual pdf 17 page image

17When installing the camera on a wall or a ceiling, there are two methods as specified below. (pages 18 - 20)• Using a two-gang junction box• Using supplied mount bracketImportant:• Procure 4 screws (M4) to secure the camera attachment (accessory) or the camera mountbracket (accessory) to a wall or a ceiling according to the material of the installation area.Do not use wood screws and nails.Use anchor bolts (M4) for securing if the ceiling is made of concrete.(Recommended tightening torque: 1.6 N·m )• Be sure to mount the camera attachment with the arrow facing upward.• Required pull-out capacity of a single screw/bolt is 196 N or more.• If a ceiling board such as plaster board is too weak to support the total weight, the areashall be sufficiently reinforced.• When using an optional mounting bracket, refer to the operating instructions of the bracketin use.Preparations*1 The conditions for securing the camera mount bracket to a wall or a ceiling are describedhere.*2 Make sure that the installed mount bracket can support more than 5 times of the weight ofthe camera.InstallationplaceApplicable mountbracketRecommendedscrewNumber ofscrewMinimum pull-outstrength (per 1 pc.)Ceiling/wallCeiling/wall*1Ceiling(two-gang junction box)Mount bracket(approx. 350 g)WV-Q169(approx. 700 g)M4M4–4 pcs.4 pcs.–196 N196 N*2