61Configuration of the settings relating to the mail notification [Notification]Click the [Notification] tab on the "Alarm" page. ( pages 20 and 21: How to display/operate the setup menu)The settings relating to the alarm mail can be configured. It is necessary to configure the settings of the mail serverto perform the mail notification. ( page 69) Mail notification[Mail server >>]When "Mail server >>" is clicked, the [Mail] tab of the"Server" page will be displayed. ( page 69)[Mail notification]Select "On" or "Off" to determine whether or not to pro-vide notification by e-mail according to the settings forthe "Alarm" and "Diag." checkboxes of "Destination ofnotification" below.• When an alarm is detected ("Alarm")• When a notification of the remaining capacity of theSD memory card has been provided ("Diag.")• When the SD memory card has become full ("Diag.")• When the SD memory card cannot be recognized("Diag.")Default: Off[Alarm image attachment]Select "On" or "Off" to determine whether or not toattach an image to the mail to be sent when an alarm isdetected.Default: OffNote:• The settings for "Image capture size" of the "Alarmimage" section on the [Alarm] tab ( page 55) willbe applied to the size of the image to be attached. Destination of notification[Address 1] - [Address 4]Enter the destination mail address. Up to 4 destinationaddresses can be registered."Alarm" checkbox: When the checkbox is checked,the mail notification will be performed upon an alarmoccurrence."Diag." checkbox: When the checkbox is checked, themail notification will be provided in the followingcases.• When notification of the remaining capacity ofthe SD memory card has been provided• When the SD memory card has become full• The SD memory card cannot be recognized"Destination address": Enter the destination address.To delete the registered address, click the [Delete] but-ton respective to the desired address.Available number of characters: 3 - 128 characters[Mail subject]Enter the mail subject.Available number of characters: 0 - 50 characters[Mail body]Enter the mail body.Available number of characters: 0 - 200 charactersNote:When the SD memory card becomes full, notificationmail will be sent with the following message.• When the SD memory card has become full:"The SD memory card is full."• When mounting of the SD memory card failed:"The SD memory card cannot be recognized."Step 6Click the [Set] button.→ The edited settings will be applied.
