59[Area]When selecting a VMD area in the screen, it will benumbered as area 1. (Subsequent areas will be num-bered in the order of selection.)[Status]Select "On" or "Off" to determine whether or not to acti-vate each VMD area.On: Activates the respective VMD area.Off: Inactivates the respective VMD area.Default: Off[Detection area]Adjust the size of the VMD area using the slider. Thesmaller the selected value is, the higher the sensitivityof VMD area becomes. The current value (1-10) will bedisplayed on the right of the slider.Default: 1[Detection sensitivity]Adjust the sensitivity of motion detection in the VMDarea using the slider. The settings can be configured foreach area individually. The larger the value is set, thehigher the sensitivity level becomes.The current value (1 (low) - 15 (high)) will be displayedbelow the slider.Default: 8[Delete] buttonClick the [Delete] button corresponding to the area to bedeleted. The outline of the selected area will be deleted.[Light detection control]Select "On" or "Off" to determine whether or not todetect video motion affected by brightness change suchby a dimming level control.Default: OffImportant:• "Light detection control" may not work when bright-ness change is too small.• When "On" is selected for "Light detection control",the video motion detection may sometimes not beperformed even when detecting a subject movingover the whole screen.Set the VMD areas [VMD area]Click the [VMD area] tab on the "Alarm" page. ( pages 20 and 21: How to display/operate the setup menu)The video motion detection areas can be set on this page.Up to 4 areas can be set. When motion is detected in the set area, it will be regarded as an alarm.Important:• The alarm occurrence indication button ( page 8) will be displayed when motion is detected by the VMD func-tion.• The alarm occurrence indication button will be displayed when receiving an alarm input of a terminal alarm or acommand alarm.• Depending on the network environment, notification may be delayed even when "Real time" is selected for"Alarm status update mode" on the [Basic] tab of the "Basic" page ( page 25).• The motion detection function is not the dedicated function to prevent thefts, fires, etc. We are not responsible forany accidents or damages occurring in case.
