54Configure the alarm settings [Alarm]The settings relating to alarm occurrences such as settings for the alarm action at an alarm occurrence, the VMDarea settings, and the alarm occurrence notification can be configured on this page.The "Alarm" page has 3 tabs; the [Alarm] tab, the [VMD area] tab and the [Notification] tab.Configure the settings relating to the alarm action [Alarm]Click the [Alarm] tab on the "Alarm" page. ( pages 20 and 21: How to display/operate the setup menu)The settings relating to the alarm can be configured in this section. Refer to pages 55 and 57 for further informationabout the settings relating to the alarm and the alarm output terminal. Alarm[Terminal 1]Determine how to use terminal 1.Alarm input: Receives alarms.Black & white input: Receives the black & whiteswitchover input. (When the input is set to On, theblack & white mode is activated.)Off: Not used.Default: Off[Terminal 2]Determine how to use terminal 2.Alarm input: Receives alarms.Alarm output: Alarm output will be carried out accord-ing to the settings for "Alarm output terminal setup"( page 57).Off: Not used.Default: Off[Terminal 3]Determine how to use terminal 3.Alarm input: Receives alarms.AUX output: AUX output will be supplied. The [AUX]buttons will be displayed on the "Live" page.Exposure output: The CCD exposure timing pulseoutput is provided. (The close output is providedonly during CCD exposure.)Off: Not used.Default: OffNote:• AUX is a camera terminal that allows users to oper-ate (Open/Close) arbitrarily from the "Live" page. Forexample, an operator can remotely control lights in aplace where the camera is installed by connectingthe terminal to the light controller.• Refer to the installation guide for further informationabout input/output terminals.[VMD alarm]When clicking "VMD >>", the [VMD area] tab of the"Alarm" page will be displayed.[Command alarm]Select "On" or "Off" to determine whether or not toreceive the command alarm.The command alarm is the function that provides notifi-cation of a Panasonic protocol alarm from the othercameras. When "On" is selected, alarm actions will beperformed between multiple cameras.Default: Off[Originating port number]Select a port number to be used to receive the com-mand alarm.Available range: 1 - 65 535Default: 8 181
