Before starting the connection, make sure that the power of the devices to be connected suchas the camera and a PC are off or the power cords of the devices are disconnected.Before starting the connection, prepare the required devices and cables.z Connect an RCA plug to the monitor out connec-tor provided on the rear only for adjustment of theangular field of view on the video monitor.Important:• The monitor out connector is provided only forchecking the adjustment of the angular field ofview on the video monitor when installing the cam-era or when servicing.It is not provided for recording/ monitoring use.23ConnectionFOCUSASSIST LINKPOWERAUDIO OUT MIC INEXT I/O1 2 3 4C B AMONITOR OUTSDCARD12V IN24V INACT100BASE-T/100BASE-TXConnect to thevideo monitor, etc.FOCUSASSIST LINKPOWERAUDIO OUT MIC INEXT I/O1 2 3 4C B AMONITOR OUTSDCARD12V IN24V INACT100BASE-T/100BASE-TX!@C B APower cord plug (provided)Approx. 3 mm - 7 mmTo power source(24 V AC/12 V DC)x Connect to the power source.Important:• 24 V AC/12 V DC power supply shall be insulatedagainst 120 V AC.• When connecting to 24 V AC/12 V DC powersourceq Loosen the screw of the provided power cordplug.w Insert the power cord of an optional AC adapter tothe power cord plug.When using 24 V AC/12 V DC power supply otherthan the WV-PS16 (option), remove 3 mm - 7 mm{1/8" - 9/32"} of the outer jacket of the power cordfrom a power supply and twist the core of thepower cord to prevent a short circuit.AC24 V DC12 VA N @(GND)B GND NCC L !* Make sure that the power cord plugis inserted to the power cord termi-nal firmly.Specification of cord (wire): AWG #22 - #28single core, twisted* Make sure that the exposed core wires arecompletely hidden after inserting the powercord.e Tighten the screws to fix the inserted powercord.r Connect the power cord plug to the 24 VAC/12 V DC power cord terminal on the rearof the camera.Caution:ONLY CONNECT THIS TO 24 V AC OR 12 V DC CLASS 2 POWER SUPPLY.