Panasonic WV-NP304 Installation Manual

Also see for WV-NP304: Product catalog Integration note Brochure Reference Comparison chart

Panasonic WV-NP304 Installation Manual Manual pdf 19 page image

Attach a safety wireThe following is a safety wire attachment example. Procure an appropriate safety wire kitaccording to the installing place.Refer to the operating instructions of the safety wire kit in use together with this installationguide when attaching a safety wire.Important:• To prevent the camera from dropping that may cause accidental injury, attach a safetywire between the camera and the installing place. Contact your dealer for attachment of asafety wire.When installing on a ceiling• Camera mount bracket: WV-7010A• Safety wire kit: WV-Q141z Detach the tripod mount base from the camera.x Fix the tripod mount base and the safetywire attachment bracket for ceilingmount (provided) using the fixing screw.Use the removed screw (used to fix thetripod mount base).When a screw other than the removedscrew (with a different height) is used, itmay result in drop or damage of thecamera.Recommended tightening torque: 0.39N·m {4 kgf·cm}c Attach the two safety wires to the safety wire attachment holes (front/rear).q Pass the loop end of the safety wire through the safety wire attachment hole.w Hook the loop end of the safety wire on the safety wire hook.19Safety wire attachment holeSafety wire Safety wire hookInstallationTTripod mount baseFixing screwSafety wireattachmentbracket for ceilingmount (provided)Safety wireattachment hole(rear)Safety wireattachment hole(front)