Panasonic WV-NF302 Installation Manual

Also see for WVNF302 - NETWORK CAMERA: Product catalog Integration note Brochure Reference Comparison chart

Panasonic WV-NF302 Installation Manual Manual pdf 19 page image

19Installation of the camera mountbracketStep 1Make a hole in the ceiling.If the camera is directly mounted on awall/ceiling, align the camera mounting posi-tion with the position of the hole throughwhich the cables run and make the hole.Note:Mounting on a two-gang junction box(locally procured) is available since thescrew holes of the provided cameramount bracket is also designed formounting on it.Step 2Fix the camera mount bracket.Important:• Procure 4 mounting anchor bolts accord-ing to the material of the installation area.In this case, wood screws and nailsshould not be used.Recommended tightening torque is asfollows.M4: 1.6 N·m {1.18 lbf·ft}• Required pull-out capacity of a singlebolt is 196 N {44.1 lbf} or more.• If a ceiling board such as plaster boardis too weak to support the total weight,the area shall be sufficiently reinforced.• The protection sheet attached to thedome cover shall be peeled off afterinstallation.Note:It is also possible to mount the cameraon a ceiling or a wall without making ahole. To mount the camera without mak-ing a hole, it is necessary to remove thetab of the camera to open the wiring holeas shown in the illustration.Ceiling board Make a holeø75 mmAnchor bolt x4 (not provided,M4 or equivalent)Camera mountbracketCeiling GNDAUXALARM OUTALARM IN10BASE-T/100BASE-TXACT LINKMIC IN12VAUDIO OUTINITIALSETRemove the tab using a pliers, etc.Wiring hole46 mm83.5 mmø117.5 mmSide cable hole4-ø4.7 mmCeiling cablehole