Panasonic WV-NF302 Installation Manual

Also see for WVNF302 - NETWORK CAMERA: Product catalog Integration note Brochure Reference Comparison chart

Panasonic WV-NF302 Installation Manual Manual pdf 18 page image

18Installations/ConnectionsInstallation of the cameraBefore starting the installation/connection, prepare the required devices and cables. Refer tothe corresponding pages for further information.z Make a hole in the ceiling and fix the provided camera mount bracket over it. ( page 19)x Line up the ends of the cables (12 V DC power cable, LAN cable (category 5 or higher),cable from an external device and the provided audio cable) and the safety wire, and thenbundle them using the provided cable tie. ( page 20)c Attach the provided safety wire to the safety wire holder of the camera. ( page 20)v Make the connections of the 12 V DC power cable, LAN cable, audio cable and cable froman external device. ( pages 22 - 24)b Mount the camera onto the camera mount bracket. ( page 20)n Adjust angle of the camera, angular field of view and focus. ( pages 26 - 28)Note:When the camera is installed just above the photogenic subjectas q in the illustration, it may be difficult to adjust angular fieldof view focusing around the subject.To easily adjust angular field of view focusing around the sub-ject, increase an angle (A) as w.(A)q wSubjectSafety wireCeilingSafety wire holder12 V DC power cable Cable from an external deviceCamera mount bracket(provided as a standardaccessory)Cable tie (provided as astandard accessory)Anchor bolt x4(not provided)LAN cable Audio cable (provided as a standardaccessory)Bundle the cables andthe safety wire togetherCaution:ONLY CONNECT THIS TO 12 V DC CLASS 2 POWER SUPPLY.