Panasonic WV-NF302 Installation Manual

Also see for WVNF302 - NETWORK CAMERA: Product catalog Integration note Brochure Reference Comparison chart

Panasonic WV-NF302 Installation Manual Manual pdf 16 page image

16Precautions for InstallationAll work related to the installation of thisproduct should be made by qualified serv-ice personnel or system installers.Use this product for indoor use only.Do not expose this product to direct sunlightfor hours and do not install the product neara heater or an air conditioner. Otherwise, itmay cause deterioration, discoloration andmalfunction. Keep this product away fromwater.Avoid installing in the following locations.• Locations where it may get wet from rainor water splash (not only indoor)• Locations where a chemical agent isused such as a swimming pool• Locations subject to steam, oil smoke,high humidity and excessive dust• Locations near flammable gas or vapor• Locations where radiation or x-ray emis-sions are produced• Locations where corrosive gas is pro-duced• Locations where it may be damaged bybriny air such as seashores• Locations where the temperature is notbetween –10 °C - +50 °C {14 °F - 122 °F}• Locations subject to vibrations (Thisproduct is not designed for on-vehicleuse.)• Locations subject to condensation as theresult of severe changes in temperature(The dome cover may be fogged or con-densation may be formed.)Be sure to remove this product if it is notin use.Before installation• The mount bracket specified in page 21shall be used to mount this product.• The screws specified in page 21 shall beused when this product and cameramount bracket are mounted on a ceilingor a wall. The screws to be used are notsupplied. Prepare the screws accordingto the material, structure, strength andother factors of the mounting area andthe total weight of objects to be mounted.• The anchors, screws to be used andinstallation surface shall be sufficientlystrong.• The surface made of plasterboard orwood shall not be selected for mountingposition because of its insufficientstrength. If there is no choice other thanthe surface of plasterboard or wood, themounting position shall be sufficientlyreinforced.Mounting screwsOnly the fixing screws are provided to fix thecamera with the provided camera mountbracket. It is necessary to procure screws orbolts to mount the camera. Prepare themaccording to the material and strength of thearea where the camera is to be installed. Thescrews and bolts must be tightened with anappropriate tightening torque according tothe material and strength of the installationarea.An impact driver shall not be used. Failure toobserve this may damage the screws.Be sure to install the safety wire.Make sure that the safety wire attached to thecamera mount bracket is securely connectedto the camera main body.