Panasonic Viera U50A series Operating Instructions Manual

Contents

Panasonic Viera U50A series Operating Instructions Manual Manual pdf 16 page image

Auto Tuning16Auto TuningSearch and store TV channels automatically.● These steps are not necessary if the setup has been completed by your local dealer.● Please complete connections (p. 12 - 15) and settings (if necessary) of the connected equipment before starting AutoTuning. For details of settings for the connected equipment, read the manual of the equipment.TV1 Plug the TV into mains socket and switch on(p. 10, 13)● Takes a few seconds to be displayed.● If the red LED shows on the TV, press the Standby On / Off switch on theremote control.2 Select your areaNew South Wales / Australian Capital TerritoryVictoriaQueenslandSouth AustraliaWestern AustraliaNorthern TerritoryTasmaniaSelect State / Territory selectset3 Select the mode to tuneDATV Signal SelectionDigital TVAnalogue TVStart Auto Tuningselecttune / skip tuning: tune (search for the available channels): skip tuning4 Select [Start Auto Tuning]DATV Signal SelectionDigital TVAnalogue TVStart Auto Tuningselectaccess● Auto Tuning will start to search for TV channels and store them.The stored channels and sorted channel order vary depending on the area,broadcasting system and conditions of signal reception.Analogue Scan 21 68Analogue Scan 68CH 6CH 06975626262622933101010--CBBC ChannelBBC Radio WalesE4Cartoon Nwk10SearchingRF Ch Channel Name TypeDigital TVDigital TVDigital TVQualityDigital TV: 4 Analogue TV: 2Auto TuningDigital TV ScanThis will take about 6 minutes.Digital TVAnalogue TV ScanAnalogue TVAnalogue TV5 Setup the wireless LAN connectionSetup the network connection to use DLNA features. (p. 53)● To setup the wireless connection, the Wireless LAN Adaptor (optional accessory)is required. Please note that this TV does not support wireless public access points.● Ensure the network connections (p. 15) and network environment are completedbefore starting setup.Start wireless LAN connection setup?Yes No selectaccess● To setup later on or skip this stepSelect [No]