Using Network Services (DLNA)55Wired connection settingsThis setting is for the network connection by using the LAN cable.1 Select [Network Type] and set to [Wired]Network TypeConnection TestAccess Point SettingsIP/DNS SettingsMAC AddressNetwork SetupWired12-34-56-78-9a-bcselectsetIf you make the network connection like “Example 2” (p. 54), you do nothave to set [Acquire DNS Address].2 Select [IP/DNS Settings] and set the itemsNetwork SetupIP/DNS Settings Accessselectaccess■ [Acquire IP Address] / [Acquire DNS Address]Sets [IP Address], [Subnet Mask], [Gateway], and [DNS Address].Select [Acquire IP Address] / [Acquire DNS Address] and set to [Auto] (recommended).IP AddressAcquire IP AddressSubnet MaskGatewayDNS AddressIP/DNS SettingsAutoAutoAcquire DNS Address● The available settings are displayed automatically.Manual settings ([IP Address], [Subnet Mask], [Gateway], [DNS Address])selectsetabc defjk lghi mnotuvpqrs wxyz3 Select [Connection Test] and access to testNetwork SetupConnection Test Accessselectaccess● Performs automatic testing of the network connection for the TV. (It takes awhile to test.)Check network cable connection.Check acquired IP address.Check for devices using same IP address.Check gateway connection.Connection Test : succeededThe test is successful and the TV is connected to the network.: failedCheck the settings and connections. And then try again.Wireless connection settingsThis setting is for the wireless network connection.● Confirm the encryption key, settings and positions of your access point before starting setup. For details, read themanual of the access point.1 Select [Network Type] and set to [Wireless]Network TypeConnection TestAccess Point SettingsIP/DNS SettingsMAC AddressNetwork SetupWireless12-34-56-78-9a-bcselectset2 Select [Access Point Settings]Network TypeConnection TestAccess Point SettingsIP/DNS SettingsMAC AddressNetwork SetupWireless12-34-56-78-9a-bcAccessselectaccess