Panasonic Viera TX-L32G20BA Operating Instructions Manual

Contents

Panasonic Viera TX-L32G20BA Operating Instructions Manual Manual pdf 9 page image

Identifying ControlsQuick StartGuide9Using the On Screen DisplaysMany features available on this TV can be accessed via the On Screen Display menu.How to use remote control MENU Open the main menu EXIT Exit the menu system and return to thenormal viewing screenMove the cursor / select the menu item Move the cursor / adjust levels / select froma range of optionsAccess the menu / store settings afteradjustments have been made or optionshave been setBACK/RETURN Return to the previous menuON SCREEN HELP Instructions box - Operation guideExample (Owner ID):EXITRETURNPIN entry0 9Please enter new PINPINOwner ID* * * *Operation guide will help you.Changes the input modeTVC.A.T.S. (Contrast Automatic Tracking System) sensor• Senses brightness to adjust picture quality when “C.A.T.S.” in the Picture Menu is setto “On” (p. 32).Mains power On / Off switch• Use to switch mains power On / Off.If TV was switched off whilst in Standby mode, using theMains Power On / Off switch, then it will be in Standby modewhen switched back on using the same switch.For changing TV channel up or down. When a functionis selected by the ‘F’ button, press to increase ordecrease the setting of the selected function. When inStandby mode, press either button for about 1 second toswitch the TV On.Function selectVolume / Contrast / Brightness / Colour / Sharpness / Tint (NTSC signal) / Bass (“Music” or “Speech” mode in theSound Menu) / Treble (“Music” or “Speech” mode in theSound Menu) / Balance / Auto Setup (p. 40 and p. 41)Power and Timer LEDRed : StandbyGreen: OnOrange: Timer Programming OnOrange (flash): Recording of Timer Programming, Direct TV Recording orOne Touch Recording is in progressRed withorange flash: Standby with Timer Programming On, Direct TV Recording orOne Touch RecordingThe LED blinks when the TV receives a command from the remote control.Remote control signal receiverDo not place any objects between the TV remote control signal receiver and remote control.Auto power standby function The TV will automatically go to Standby mode in the following conditions: no signal is received and no operation is performed for 30 minutes in Analogue TV mode•“Off Timer” is active in the Setup Menu (p. 19)•no operation is performed for the period selected in “Auto Standby” (p. 36)•This function does not affect the recording of Timer Programming, Direct TV Recording and One Touch Recording.AV3RLVHDMI 42Headphonesjack (p. 93)CI Slot(p. 57)HDMI4 terminal(p. 93)SD Card slot(p. 66)AV3 terminals(p. 93)USB 2 port(p. 13, 62, 66and p. 75)