Panasonic Viera TX-L32G20BA Operating Instructions Manual

Contents

Panasonic Viera TX-L32G20BA Operating Instructions Manual Manual pdf 4 page image

4Safety PrecautionsWarningMains plug and leadTo help avoid risk of electrical shock, fire, damage or injury, please follow the warnings below:This TV is designed to operate on AC 220-240 V, 50 Hz.Insert the mains plug fully into the socket outlet. Ensure that the mains plug is easily accessible. Remove the mains plug when cleaning the TV.Do not touch the mains plug with a wet hand.Do not damage the mains lead.Do not place a heavy•object on the lead.Do not place the lead•near a high temperatureobject.Do not pull on the lead.•Hold onto the mains plugbody when disconnectingthe plug.Do not move the TV with the lead plugged into a•socket outlet.Do not twist the lead, bend it excessively or•stretch it.Do not use a damaged mains plug or socket outlet.•Ensure the TV does not crush the mains lead.•AC 220-240 V50 HzIMPORTANT: THE MOULDED MAINS PLUGFOR YOUR SAFETY, PLEASE READ THE FOLLOWING TEXT CAREFULLY.This TV is supplied with a moulded three pin mains plug for your safety and convenience. A 5 amp fuse is fittedin this mains plug. Shall the fuse need to be replaced, please ensure that the replacement fuse has a rating of 5amps and that it is approved by ASTA or BSI to BS1362.Check for the ASTA mark ASA or the BSI mark on the body of the fuse.If the mains plug contains a removable fuse cover, you must ensure that it is refitted when the fuse is replaced.If you lose the fuse cover the mains plug must not be used until a replacement cover is obtained.A replacement fuse cover may be purchased from your local dealer.If the fitted moulded mains plug is unsuitable for the socket outlet in your home, then the fuse shall beremoved and the mains plug cut off and disposed of safety. There is a danger of severe electrical shockif the cut off mains plug is inserted into any 13 amp socket.If a new mains plug is to be fitted, please observe the wiring code as shown below.If in any doubt, please consult a qualified electrician.IMPORTANT: – The wires in this mains lead are coloured in accordance with the following code: –Blue: Neutral Brown: LiveAs the colours of the wire in the mains lead of this appliance may not correspond withthe coloured markings identifying the terminals in your mains plug, proceed as follows.The wire which is coloured BLUE must be connected to the terminal in the mains plugwhich is marked with the letter N or coloured BLACK.The wire which is coloured BROWN must be connected to the terminal in the mains plug whichis marked with the letter L or coloured RED.Under no circumstances should either of these wires be connected to the Earth terminal of thethree pin mains plug, marked with the letter E or the earth symbol .How to replace the fuseFor plug type shown in example 1:Lift out the removable fuse compartment with a screwdriver and replace the fuse, then refitsecurely into the mains plug (see example 1).For plug type shown in example 2:Lift open the fuse compartment, in the mains plug, with a screwdriver, and replace the fuse,then press the fuse cover down securely (see example 2).Example 1Example 2If you detect anything unusual,immediately switch off the mains supplyswitch and remove the mains plug.