Panasonic Viera TH-58PF11 Operating Instructions Manual

Also see for TH-65PF11UK - 64.8" Plasma Panel: Specifications Operating instructions manual Service manual Operating instructions manual

Contents

Panasonic Viera TH-58PF11 Operating Instructions Manual Manual pdf 9 page image

1 2SERIALPC INAUDIOSLOT1 SLOT3PR /CR /R PB/CB/B Y/GAUDIOR LCOMPONENT/RGB INSLOT212 12129Connections– Cable fi xing bandSecure any excess cables with band as required.Note:Make sure that the ACcord is locked on boththe left and right sides.Push untilt h e h o o kclicks.2. Pull off.1. Keep theknobpressed.CloseOpen1 Plug the AC cord intothe display unit.Plug the AC cord until itclicks.2 Fix the AC cord with the clamperwhich is attached to the unit.For TH-42PF11UK, TH-58PF11UK :Clampers are not installed to thisunit. Ensure there is sufficient slackin the AC cord and firmly bind withthe supplied cable fixing band, etc.Note:One fixing band is supplied with this unit. In case of securing cables at two positions, please purchase it separately.Speakerterminal (R)Speakerterminal (L)When connecting the speakers, be sure to use only the optional accessory speakers.Refer to the speaker’s Installation Manual for details on speaker installation.Speakers (Optional accessories)Pass the attached cablefixing band through the clipas shown in the figure.To secure cables connected to Terminals, wrap the cable fixing band around them thenpass the pointed end through the locking block, as shown in the figure.While ensuring there is sufficient slack in cables to minimize stress (especiallyin the power cord), firmly bind all cables with the supplied fixing band.From SERIALTerminal onComputer(see page 11)From EXTERNALmonitor terminalon Computer(see page 10)AC cord connection (see page 13)Dual HDMI Terminals(equivalent of DualHDMI Terminal Board(TY-FB10HMD))(see page 12)To tighten: To loosen:PullPullPush the catchNote: At factory shipment, Terminal boards are installed in SLOT 2 and SLOT 3.– AC cord fi xingOptional TerminalBoard Insert Slot(covered)COMPONENT/RGB IN andAudio IN Terminals (equivalentof BNC Component VideoTerminal Board (TY-42TM6A))(see page 12)Unplug the AC cordUnplug the AC cordpressing the twoknobs.Note:When disconnecting the AC cord,be absolutely sure to disconnectthe AC cord plug at the socketoutlet first.