1/2SIGNALSCREENSAVERPCOFFSTANDBY SAVE OFFPOWER MANAGEMENT OFFAUTO POWER OFF OFFOSD LANGUAGE ENGLISH (US)COMPONENT/RGB-IN SELECTRGBINPUT LABELPOWER SAVESET UPSCREENSAVERSTARTFUNCTIONWOBBLINGPEAK LIMITFINISH TIMESTART TIMESCROLLING BAR ONLY6:1512:30OFFOFFSIDE BAR ADJUST BRIGHTPRESENT TIME OF DAY 99:99MODE OFFSCREENSAVERSTARTFUNCTIONMODEFINISH TIMESTART TIMESCROLLING BAR ONLYTIME OF DAY6:1512:30PRESENT TIME OF DAY 15:00SCREENSAVERSTARTFUNCTIONMODESAVER DURATIONSHOW DURATIONSCROLLING BAR ONLYINTERVAL12:003:00PRESENT TIME OF DAY 15:0030Do not display a still picture, especially in 4:3 mode, for any length of time.If the display must remain on, a SCREENSAVER should be used.FUNCTION selection2314Press to display the SET UP menu.Press to select the SCREENSAVER.Press to select the SCREENSAVER screen.MODE selectionSTART setting5 When the MODE is set to ON, press to select START.Press to start SCREENSAVER.The menu screen will disappear and the SCREENSAVER will be activated. To stop theSCREENSAVER under ON, press the R button or any buttons on the main unit.Note: When the display is turned off, the SCREENSAVER will be deactivated.Press to select the MODE.Press to select each modeitems.SCREENSAVER (For preventing image retention)Setup of SCREENSAVER TimeAfter selecting TIME OF DAY or INTERVAL, the relevant Time Setup will become available for selection and the OperatingTime may be set. (Time cannot be set when “MODE” is “ON” or “OFF”.)Press to select START TIME / FINISH TIME (When TIME OF DAY is selected).Press to select SHOW DURATION / SAVER DURATION (WhenINTERVAL is selected).Press to setup.button: Forwardbutton: BackNote: Timer function will not work unless “PRESENT TIME OF DAY” is set.Notes:• Pressing “ ” or “ ” button once changes the Time 1 minute.[However, switching occurs every 15 minutes when Periodic Time is selected.]• Pressing “ ” or “ ” button continuously changes the Time by 15 minutes.OffINTERVAL : Operates when SHOW DURATION and SAVERDURATION are set up and those times arrive.TIME OF DAY : Operates when START TIME and FINISH TIMEare set up and those times arrive.ON : Operates when START is selected and theACTION ( ) button is pressed.Note: OVERLAY SCROLLING BAR is not effective during two screen display.Press to select the FUNCTION.Press to select the desired function.SCROLLING BAR ONLYOVERLAY SCROLLING BARNEGATIVE IMAGEWHITE SCREENNEGATIVE IMAGE : A negative image will be displayed on the screen.SCROLLING BAR ONLY : A white bar will scroll from left to right. The image won't be displayed.OVERLAY SCROLLING BAR : The brightness of the image will be decreased and a white bar will scroll on it.WHITE SCREEN : The whole screen will be white.