Panasonic Viera TH-58PF11 Operating Instructions Manual

Also see for TH-65PF11UK - 64.8" Plasma Panel: Specifications Operating instructions manual Service manual Operating instructions manual

Contents

Panasonic Viera TH-58PF11 Operating Instructions Manual Manual pdf 41 page image

3D Y/C FILTER (NTSC)COLOR SYSTEMSIGNALONAUTO3 : 2 PULLDOWNPanasonic AUTO (4 : 3)OFF4:3[ VIDEO ]3 : 2 PULLDOWN OFFXGA MODE 1024 × 768413:2 PULLDOWNCOLOR SYSTEM / Panasonic AUTOSelect SIGNAL from the “SET UP” menu during VIDEO (S VIDEO) inputsignal mode.(“SIGNAL [VIDEO]” menu is displayed.)SET UP for Input SignalsPress to select the “COLOR SYSTEM” or “Panasonic AUTO”.Press to select each function.If the image becomes unstable:With the system set on Auto, under conditions of low level or noisyinput signals the image may in rare cases become unstable. Should this occur,set the system to match the format of the input signal.Press to select “3:2 PULLDOWN”.Press to set ON/OFF.3:2 PULLDOWN: When ON, the display attempts to reproduce a more natural interpretation of sources such as moviepictures, which are recorded at 24 frames per second.If the picture is not stable, turn the setting to OFF.Notes:When ON, this setting only affects the following signal input:• NTSC / PAL signal input during “VIDEO (S VIDEO)” input signal.• 525i(480i), 625i(575i), 1125(1080)/60i signal input during “COMPONENT” input signal.Mode FunctionCOLOR SYSTEM Set the color system to match the input signal. When selecting “AUTO”, the color system is automaticallyselected from NTSC/PAL/SECAM, however, M.NTSC signal is not displayed properly depending onthe attached terminal board. To display M.NTSC signal, select “M.NTSC” in COLOR SYSTEM.AUTO SECAM M.NTSC NTSCPALPanasonic AUTO(4 : 3 )Set to “4:3” to view 4:3 images in an unchanged format when Panasonic AUTO is selected.If you would like to view 4:3 images in Just format, set to “JUST”.Note:Panasonic AUTO does not function when BNC Dual Video Terminal Board (TY-FB9BD) is used.XGA MODEThis menu is displayed when the input signal is analog (Component/PC). This unit supports three types of XGA signalswith 60Hz vertical frequency having different aspect ratios and sampling rates (1,024 × 768 @ 60Hz, 1,280 × 768 @ 60Hz,and 1,366 × 768 @ 60Hz). Be sure to make settings in accordance with the input signal in order to achieve a moreappropriate and attractive display.In addition, after making this setting, be sure to make each adjustment (such as “AUTO SETUP”) on the “POS. /SIZE”menu as necessary. (see page 24)Press to select “XGA MODE”.Press to select “1024×768”, “1280×768” ,“1366×768”.