Panasonic VL-W600BX Operating Instructions Manual

Panasonic VL-W600BX Operating Instructions Manual Manual pdf 20 page image

Camera20Answering a call from the cameraWhen the sensor detects motion, the sub monitor station rings and the {CAMERA} button flashes. The image takenby the camera appears on the display.1 When a ringer tone is heared, press {CAMERA}.LYou will hear the sound from the camera.(The sound from your end will not be heard at the camera.)NTo speak to the other party at the camera:Press {TALK}.NTo adjust the speaker volume:Press {▲ } or {▲}.NTo adjust the display brightness:Press {BRIGHT} (page 8).2 To end monitoring or the conversation, press {OFF}.Note:LIf you do not answer a call within 30 seconds, the display will turn off. Monitoring or the conversation willautomatically end in about 90 seconds and then the display will turn off.LThe image taken at the time of detection and 3 more images (4 images in total) are automatically recorded atabout a 3 second interval after detection. Even if you do not answer a call, the images are recorded (page 21).LYou can record a set of images manually while monitoring the display (page 21).LYou can change the ringer tone by using the main monitor station (see the Operating Instructions included withthe main monitor station).LDuring standby, you can change the ringer volume by pressing {◄} or {►}.LWhen you talk to the camera, make sure you are within about 50 cm of the camera.LWhen it is difficult to hear the visitor’s voice or you want to speak with modified voice, use “Press-to-talk” mode orvoice changer (page 16).LWhen you receive another call from the door station or another camera while receiving a call, the display isswitched to the image from the device calling later.LWhen you receive another call from the door station or another camera while monitoring or during conversation,see page 18.{OFF}{TALK}{BRIGHT}{CAMERA}{▲ } {▲ }{▲ } {▲}