Panasonic VL-W600BX Operating Instructions Manual

Panasonic VL-W600BX Operating Instructions Manual Manual pdf 15 page image

Doorphone15Answering a callWhen you receive a call from a door station, the sub monitor station rings and the TALK indicator flashes. You canmonitor the visitor on the monitor display before answering a call.1 When a ringer tone is heard, press {TALK}.2 Speak to the visitor.LSpeak alternately with the visitor.(If you and the visitor speak at the same time,you will not hear each other.)NTo adjust the speaker volume:Press {▲ } or {▲}.NTo adjust the display brightness:Press {BRIGHT} (page 8).3 To end the conversation, press {OFF}.Note:LIf you do not answer a door call within 30 seconds, the display will turn off. A conversation will be automaticallydisconnected in about 90 seconds and then the display will turn off. To turn on the display and talk to the visitoragain, press {TALK}.LThe image taken by the door station is automatically recorded. Even if you do not answer a call, the image isrecorded (page 21).LYou can record an image manually while monitoring the display during a call (page 21).LYou can change the ringer tone by using the main monitor station (see the Operating Instructions included withthe main monitor station).LAt night or when there is not enough lighting in the doorway, the display will be shown in black and white.When using an additional door station or camera:LWhen you receive another call from an additional door station or an additional camera while receiving a previouscall, the display is switched to the image from the device calling later.LWhen you receive another call from an additional door station or an additional camera during conversation, seepage 18.Answering a call by voice sensor (Voice answer mode)This mode allows you to answer a call by voice without pressing {TALK}. Voice answer must be set “ON”beforehand (page 26).1 When a ringer tone is heard, answer with a clear voice such as “Yes?” or “Hello?”(The visitor cannot hear your initial reply when you answer with voice.)LWhen a beep sounds, you can talk to the visitor.Note:LMake sure you are within about 50 cm of the sub monitor station.LYour initial reply should be brief (less than 1 second), otherwise the voice answer mode will not start.LIf a visitor calls you, a loud, brief sound (such as a barking dog) may start the voice answer mode even thoughyou have not replied by voice.LWhen you locate the sub monitor station near the main monitor station, the voice answer mode may be started bya ringer tone.LThe voice answer mode is also available for paging calls.{OFF}{TALK}TALK indicator{BRIGHT}{▲ } {▲}