Panasonic TX-40C200E Operating Instructions Manual

Panasonic TX-40C200E Operating Instructions Manual Manual pdf 11 page image

English - 11 -ConnectionsConnector Type Cables DeviceScartConnection(back)VGAConnection(back)SIDE AV PC/YPbPrAudioConnection(side) Side Audio YPbPr or PCConnection CableHDMIConnection(back)SPDIFConnection(back)SIDE AV Side AV(Audio/Video)Connection(side)HEADPHONEHEADPHONEHeadphoneConnection(side)PC to YPbPrYPbPr VideoConnection(back) PC to YPbPr Connection CableUSBConnection(side)CIConnection(side)CAMmoduleNOTE: When connectinga device via the YPbPr or SideAV input, you must use theconnection cables to enableconnection. See the illustrationson the left side. | You can useYPbPr to VGA cable (not supplied)to enable YPbPr signal via VGAinput. | You cannot use VGA andYPbPr at the same time. | Toenable PC audio, you will needto use the YPBPR/PC AUDIOCONNECTION cable’s WHITE &RED inputs. | If an external deviceis connected via the SCARTsocket, the TV will automaticallyswitch to AV mode. | Whenreceiving DTV channels (Mpeg4H.264) or while in Media Playermode, output will not be availablevia the scart socket. | When usingthe wall mounting kit (optional),we recommend that you plug allyour cables into the back of theTV before mounting on the wall.| Insert or remove the CI moduleonly when the TV is SWITCHEDOFF. You should refer to themodule instruction manual fordetails of the settings. | The/EachUSB input of your TV supportsdevices up to 500mA. Connectingdevices that have current valueabove 500mA may damage yourTV. | By connecting an HDMI cableto your TV, you have to use only ashielded HDMI cable to guaranteea sufficient immunity againstparasitic frequency radiation.If you want to connect a device to the TV, make sure that both the TV and the device are turned off before makingany connection. After the connection is done, you can turn on the units and use them.