- 85 -Custom - Wireless Access PointYou can use the TV as a wireless access point and connect the networkequipment without an access point.● Confirm the PIN code, network settings of the equipment before startingsetup. For details, read the manual of the equipment.1. Display the menu with MENU2. Select Network Network Connection Custom Wireless Access Pointwith / / / and press OK to access3. Select Connect to device in WPS with / and press OK to access● To set manually, select Change settings. (see below)4. Select and set WPS(Push button) / WPS(PIN) with / and press OK toaccessWPS(Push button):Set the equipment to WPS (Push button) mode. For details, read themanual of the equipment.WPS(PIN):Enter the PIN code of the equipment.● If the connection has failed, check the settings and positions of theequipment. And then, follow the on-screen instructions.■ Change settingsYou can set up Network name(SSID), Encryption key, Wireless type andChannel setting method manually.Follow the on-screen instructions and set manually.● Set Reset settings to reset the items of Change settings.= Note =● You cannot connect the internet service while the TV is set to WirelessAccess Point.● You can connect up to 7 devices. But the transfer rate will vary accordingto communication environment or the numbers of connected equipment.● To confirm the current network settingsHome network Network settings Network Status● Ensure the equipment to connect supports WPS for this setup.● WPS: Wi-Fi Protected Setup™
