Panasonic TH-70LF50U Operating Instructions Manual

Also see for TH-70LF50U: Specification

Contents

Panasonic TH-70LF50U Operating Instructions Manual Manual pdf 48 page image

48NormalizationWhen both main unit buttons and remote control are disabled due to the “Button lock”, “Remocon User level” or “RemoteID” adjustments, set all the values “Off” so that all the buttons are enabled again.Press the - / button on main unit together with button on the remote control and hold for more than 5 seconds.The “Shipping” menu is displayed and the lock is released when it disappears.Options AdjustmentsItem AdjustmentsPower On Message(No activity poweroff)Whether to show/hide No activity power off Precautions at the time of power ON is set.On: The warning precautions are shown at the time of power ON.Off: The warning precautions are not shown at the time of power ON.Note:This setting is enabled only if “NO ACTIVITY POWER OFF” is “ENABLE” (see page 34).Function button assign 1Function button assign 2Set the functions that operates when is pressed.Signal: The “SIGNAL” menu is displayed.Screensaver: The “SCREENSAVER” menu is displayed.ECO menu: The “ECO MODE SETTINGS” menu is displayed.Set up TIMER: The “SET UP TIMER” menu is displayed.Note:Factory settings are as follows.FUNCTION1 button: SignalFUNCTION2 button: ScreensaverUse the FUNCTION buttonThe menu screen is displayed. (Example: Signal)3D Y/C FILTERCOLOR SYSTEMSIGNALONAUTO3 : 2 PULLDOWN OFF[ VIDEO ]NOISE REDUCTION OFFPress the FUNCTION button to exit from the menu.Power Switch LockSets the lock setting for the display Power switch.On: Power switch operation is disabled.Off: Power switch operation is enabled.Input SearchPrimary InputOffSecondary InputInput SearchSEARCHING...Press ACTION ( ) buttonOptions 1/3On screen displayInput SearchOnInitial input OffInput SearchOff: When there is no signal, the input is not switched automatically.All Inputs: Searches all inputs and switches to an input with a signal.Priority: Searches “Primary Input” and “Secondary Input” in order and switches to an input with a signal.Primary Input, Secondary InputSet the input to search when “Priority” is selected.(NONE) SLOT INPUT* VIDEO Component/RGB PC DVI HDMI* “SLOT INPUT” is displayed when an optional Terminal Board is installed.When a Terminal Board with dual input terminals is installed, “SLOT INPUT A” and “SLOT INPUT B” are displayed.Note:• This menu is available only when “Input lock” is “Off”. (see page 46)“SEARCHING...” is displayed during the input search.1 select2 adjustInput SearchWhen a signal is not detected, another input with a signal is automatically selected.