3D Y/C FILTERCOLOR SYSTEMSIGNALONAUTO3 : 2 PULLDOWN OFF[ VIDEO ]3 : 2 PULLDOWN OFFXGA MODE 1024 ×768423:2 PULLDOWNCOLOR SYSTEMSelect SIGNAL from the “SET UP” menu during Video input signal mode.(“SIGNAL [VIDEO]” menu is displayed.)SET UP for Input SignalsPress to select the “COLOR SYSTEM” .Press to select each function.If the image becomes unstable:With the system set on Auto, under conditions of low level or noisyinput signals the image may in rare cases become unstable. Shouldthis occur, set the system to match the format of the input signal.Press to select “3:2 PULLDOWN”.Press to set ON/OFF.3:2 PULLDOWN: When ON, the display attempts to reproduce a more natural interpretation of sources such as moviepictures, which are recorded at 24 frames per second.If the picture is not stable, turn the setting to OFF.Note:When ON, this setting only affects the following signal input:• NTSC / PAL signal input during Video input signal.• 525i(480i), 625i(575i), 1125(1080)/60i signal input during Component input signal.XGA MODEThis menu is displayed when the input signal is analog (Component/PC).This menu sets two types of XGA signals with 60Hz vertical frequency having different aspect ratios and sampling rates(1,024 × 768 @ 60Hz and 1,366 × 768 @ 60Hz).When a 1,280 x 768 @ 60Hz input signal is automatically detected, the image is processed as a 1,280 x 768 @ 60HzXGA input signal irrespective of this setting.Press to select “XGA MODE”.Press to select “1024×768”, “1366×768”.Note:After making this setting, be sure to make each adjustment (such as “AUTO SETUP”) on the “POS. /SIZE” menu asnecessary. (see page 25, 26)COLOR SYSTEM: Set the color system to match the input signal. When “AUTO” is set, COLOR SYSTEM will be automaticallyselected from NTSC/PAL/SECAM/NTSC 4.43/PAL M/PAL N.To display PAL60 signal, select “AUTO”.AUTO SECAM NTSC PAL M PAL NNTSC 4.43PAL