Panasonic TH-70LF50U Operating Instructions Manual

Also see for TH-70LF50U: Specification

Contents

Panasonic TH-70LF50U Operating Instructions Manual Manual pdf 26 page image

26While the POS. /SIZE display is active, if either the N button on the remote control is pressed at any time or the ACTION( ) button is pressed during “NORMALIZE”, then all adjustment values (except “CLOCK PHASE” and “DOT CLOCK”)are returned to the factory settings.Helpful Hint ( / NORMALIZE Normalization)H-POS Adjust the horizontal position. V-POS Adjust the vertical position.H-SIZE Adjust the horizontal size. V-SIZE Adjust the vertical size.CLOCKPHASE(During RGB and PC input signal)Eliminate the ickering and distortion.DOTCLOCK(During RGB and PC input signal)Periodic striped pattern interference (noise) may occur when a striped pattern is displayed. If this happens,adjust so that any such noise is minimized.OVERSCANTurn image over scan ON/OFF.Congurable signals are as follows:525i, 525p, 625i, 625p, 750/60p, 750/50p (Component Video, DVI, HDMI)ON OFFNotes:• “OFF” is effective during only “FULL” aspect mode.• When “OFF” is set, “H-SIZE” and “V-SIZE” cannot be adjusted.1:1 PIXELMODEAdjusts the display size when 1125i or 1125p signal is input.Notes:• “ON” is effective during only “FULL” aspect mode.• Select ON when you would like to replay 1920 × 1080 input signal.• Applicable input signal;1125 (1080) / 50i · 60i · 24sF · 24p · 25p · 30p · 50p · 60p• Select OFF when ickering is shown around the image.• H-SIZE and V-SIZE cannot be adjusted when ON is selected.OFF ONAdjusting POS. /SIZE