Panasonic TH-65VX300U Operating Instructions Manual

Also see for TENTATIVE TH-65VX300U: Brochure Manual Operating instructions

Contents

Panasonic TH-65VX300U Operating Instructions Manual Manual pdf 61 page image

61OPTIONS AdjustmentsItem AdjustmentsInternal 3D EmitterSet the infrared transmitter for the 3D Eyewear.On: Use the infrared transmitter of the unit and the external 3D IR TRANSMITTER (available separately.)Off: Use the external 3D IR TRANSMITTER (available separately.)Display sizeAdjusts the image display size on screen.Off: Sets the normal image display size on screen.On: Sets the image display size approximately 95 % of the normal image display.Off OnNotes:• This setting is valid only when the input signals are as follows;NTSC, PAL, SECAM, M.NTSC, PAL60, PAL-M, PAL-N (Video)525i, 525p, 625i, 625p, 750/60p, 750/50p, 1125/60i, 1125/50i, 1125/24sF, 1125/25p, 1125/24p,1125/30p, 1125/60p, 1125/50p, 1250/50i (Component Video, RGB, DVI, SDI, HDMI)• When “Display size” is set to “On”, “H-POS” and “V-POS” in “POS./SIZE” can be adjusted.• Refer to each board’s operating instruction for DVI, SDI, HDMI’s corresponding signals.All AspectSets All Aspect mode (advanced aspect setting) or default aspect mode.With each press of button, the aspect changes in the selected mode.Off: Default aspect modeOn: All Aspect modeAspect mode of each setting is as follows:(Example: HD signal)Off 4:3 H-FILL ZOOM FULL JUSTOn 4:3 (1) 4:3 (2) 4:3 Full Zoom1 Zoom2 Zoom3 16:9 14:9 Just1 Just2Auto SetupSets the operational mode of the automatic position adjustment in the POS./SIZE menu.Manual: Automatic position adjustment starts when is pressed on the remote control or automaticposition adjustment is executed from the POS./SIZE menu.Auto: Other than remote control or menu operation, automatic position adjustment starts:When the display power is turned ON.When the input signal is switched.Advanced MotionResolutionDisplays motion picture images at higher resolution.On OffNotes:• Please set to “Off” if images look unnatural.• This function is disabled during 3D images.Power On Message(No activity power off)Whether to show/hide No activity power off Precautions at the time of power ON is set.On: The warning precautions are shown at the time of power ON.Off: The warning precautions are not shown at the time of power ON.Note: This setting is enabled only if “NO ACTIVITY POWER OFF” is “ENABLE” (see page 43).3D Safety Precautions3D Safety Precautions show/hide is set during power ON.On: 3D Safety Precaution is shown every time when the power is ON.Off: 3D Safety Precaution is not shown when the power is ON.When the setting changes from “On” to “Off”, the conrmation screen is displayed as below. Pressing“YES” switches the setting.YES NO3D Safety PrecautionsIf Off is selected, the 3D safety precautionswill not be displayed when power is turned on.Change Setting?Memory lock Locks or unlocks saved proles. Also for setting passwords. (see page 38)