Panasonic TH-65VX300U Operating Instructions Manual

Also see for TENTATIVE TH-65VX300U: Brochure Manual Operating instructions

Contents

Panasonic TH-65VX300U Operating Instructions Manual Manual pdf 43 page image

43SETUP menuPOWER SAVEPC POWER MANAGEMENTNO SIGNAL POWER OFFNO ACTIVITY POWER OFFSTANDBY SAVEOFF ONWhen this function is turned ON, luminous level of the Plasma Display is suppressed, so power consumption isreduced.DISABLE ENABLEEquipment power supply is turned OFF when there is no signal.When this is set to ENABLE, the power supply of the unit goes Off 10 minutes after the input signals stop.DISABLE ENABLEWhen this function is set to “ENABLE”, the power is turned off (standby) automatically when there is no operation of thePlasma Display for 4 hours.Starting from 3 minutes before the turn off, the remaining time will be displayed.NO ACTIVITY POWER OFF 3MINPRESS ANY KEY TO ABORT.When the power is turned off due to this function, a message “LAST TURN OFF DUE TO’NO ACTIVITY POWER OFF’”. is displayed next time the power is turned on.Note:During the screensaver is running, this function is disabled.OFF ONWhen this function is turned ON, power consumption of the microcomputer is reduced duringpower supply standby (see page 16, 19, 20), so standby power of the set is reduced.OFF ONWhen this function is set to ON, it operates under the following conditions to turn the power on or off automatically.When no pictures (HD/VD sync signals) are detected for 30 or so seconds during PC signal input:Power is turned off (standby); the power indicator lights up orange.When pictures (HD/VD sync signals) are subsequently detected:Power is turned on; the power indicator lights up green.Notes:• This function operates only during PC signal input.• This function is effective when “SYNC” is set to “AUTO”, “COMPONENT / RGB-IN SELECT” is set to “RGB”.