Panasonic TH-65VX300U Operating Instructions Manual

Also see for TENTATIVE TH-65VX300U: Brochure Manual Operating instructions

Contents

Panasonic TH-65VX300U Operating Instructions Manual Manual pdf 27 page image

27Adjusting POS./SIZE 1:1 PIXEL MODE Adjusts the display size when 1125i, 1125p or 1250i signal is input.Notes:• Select ON when you would like to replay 1920 × 1080 input signal.• Applicable input signal;1125 (1080) / 50i · 60i · 24sF · 24p · 25p · 30p · 50p · 60p, 1250 (1080) / 50i• Select OFF when ickering is shown around the image.• H-SIZE and V-SIZE cannot be adjusted when ON is selected.OFF ON CLAMP POSITION (During Component/PC input signal)Adjusts the clamp position when black parts of the image have no detail due to underexposure or aretinged with green.Optimum value for Clamp Position adjustmentWhen black parts have no detail due to underexposure (blackout)Value that causes least blackout is the optimum.When black parts are tinged with greenValue that cancels the greenishness without causing blackout is the optimum. OVER SCAN Turn image over scan ON/OFF.Congurable signals are as follows:525i, 525p, 625i, 625p, 750/60p, 750/50p (Component Video, RGB, DVI, SDI, HDMI)ON OFFNotes:• When “OFF” is set, “H-SIZE” and “V-SIZE” cannot be adjusted.• When the “Display size” is set to “On” in the OPTIONS menu, this setting will be invalid. 1:1 PIXEL MODE (2k1k)(For 2k1k signals)When the input signal is a 2k1k signal (2048×1080 / 24p, 2048×1080 / 24sF), thedisplay size is adjusted as follows.OFF ON (LEFT) ON (CENTER) ON (RIGHT)2k1k signals can only be received when the Dual Link HD-SDI Terminal Board (TY-FB11DHD) or the Dual HD-SDI Terminal Board for 3D (TY-FB30DHD3D) is installed. HV DELAY (During Component [video format] / SDI input signal)Video blanking period is displayed.OFF H DELAY V DELAY HV DELAYNotes:This function is enabled when “Studio mode” in OPTIONS menu is set to “On” during 2D viewing.•This function can also be used with the FUNCTION button on the remote control (see page 63).•