Panasonic TH-65PF50U Operating Instructions Manual

Also see for TH-60PF50U: Operating instructions

Contents

Panasonic TH-65PF50U Operating Instructions Manual Manual pdf 57 page image

57Item AdjustmentsStudio W/BOff: Nullify all the settings adjusted.On: Sets the color temperature for TV studio.Note: Valid only when the “WARM” is set as “COLOR TEMP” in PICTURE menu.Studio GainSharpens the contrast for a better view when a part of the image is too light to see.Off: Disables “Studio Gain”.On: Enables “Studio Gain”.Note: This setting is valid only when the input signals are as follows:Component Video, RGB (analog), SDI, HDMISlot powerOff Auto OnOff: Power is not transmitted to the slot power.Auto: Power is transmitted to the slot power only when main power is on.On: Power is transmitted to the slot power when main power is on or in the standby state.Note: In some cases, power is transmitted to the slot power when main power is on or in the standby stateregardless of the slot power setting.Power On ScreenDelayOff 1 2 3.... 30You can set the power-on delay time of the displays to reduce the power load, when you press to turnon the multiple displays that are set together, for example, on MULTI DISPLAY system.Set each display’s setting individually.Off: The display will be turned on at the same time as is pressed.1 to 30 (sec.) : Set the power-on delay time (second).After pressing , the display will be powered on with time delay depending on this setting.Notes:• During this function is working, the power indicator is blinking green.• This function also works when the power recovers from failure or after plugging off and in again the power cord.After you unplug and plug the power cord in while the unit is in standby mode and also the power is beingsupplied to a terminal board, the unit will start supplying the power to the board with time delay accordingto the setting.The power indicator lights up red first and it turns orange when the power starts being supplied to the board.Clock DisplayOff: Not display the clock.On: Display the clock.The clock is displayed at the lower left of the screen when button is pressed.Note: When “DAY/TIME SETUP” is not set, the clock is not displayed even if“Clock Display” is “On” (see page 36)10:00All AspectSets All Aspect mode (advanced aspect setting) or default aspect mode.With each press of button, the aspect changes in the selected mode.Off: Default aspect modeOn: All Aspect modeAspect mode of each setting is as follows:(Example: HD signal)Off 4:3→H-FILL→ZOOM→FULL→JUSTOn 4:3 (1)→4:3 (2)→4:3 Full→Zoom1→Zoom2→Zoom3→16:9→14:9→Just1→Just2Auto SetupSets the operational mode of the automatic position adjustment in the POS./SIZE menu.Manual: Automatic position adjustment starts when is pressed on the remote control or automatic positionadjustment is executed from the POS./SIZE menu.Auto: Other than remote control or menu operation, automatic position adjustment starts:When the display power is turned ON.When the input signal is switched.RotateOff: Does not rotate the image.On: Rotates the image 180 degrees.Note: During the image is rotated, the 3D images are displayed as 2D images.Advanced MotionResolutionDisplays motion picture images at higher resolution.On OffNotes:• Please set to “Off” if images look unnatural.• This function is disabled during 3D images.Power On Message(No activity poweroff)Whether to show/hide No activity power off Precautions at the time of power ON is set.On: The warning precautions are shown at the time of power ON.Off: The warning precautions are not shown at the time of power ON.Note: This setting is enabled only if “NO ACTIVITY POWER OFF” is “ENABLE” (see page 46).Options Adjustments