20Basic ControlsRemote Control TransmitterRECALL buttonPress the “RECALL” button todisplay the current system status.1 Input label2 Aspect mode (see page 21)During 3D images (see page 37)Audio input (see page 60)Profile name (see page 33)NANODRIFT SAVER operating(see page 41)3 Off timerThe off timer indicator isdisplayed only when the offtimer has been set.4 Clock display (see page 57)Standby (ON / OFF) buttonThe Plasma Display must first be pluggedinto the wall outlet and turned on at thepower switch (see page 16).Press this button to turn the Plasma DisplayOn, from Standby mode. Press it againto turn the Plasma Display Off to Standbymode.ACTION buttonPress to make selections.ASPECT buttonPress to adjust the aspect.(see page 21)POS. /SIZE button(see page 26)PICTURE button(see page 29)Sound mute On / OffPress this button to mute the sound.Press again to reactivate sound.Sound is also reactivated when power isturned off or volume level is changed.N button(see page 28, 29, 30, 34)POSITION buttonsINPUT buttonPress to select input signal sequentially.(see page 18)ECO MODE (ECO)Press to change the ECO MODEsetup status. (see page 43)FUNCTION buttons (FUNCTION)(see page 45)Digital Zoom (see page 22)AUTO SETUP buttonAutomatically adjusts the position/size of the screen. (see page 26)SETUP button (see page 35)SOUND button (see page 34)Volume AdjustmentPress the Volume Up “+” or Down “–”button to increase or decrease thesound volume level.R button (see page 25)Press the R button to return toprevious menu screen.OFF TIMER buttonThe Plasma Display can be preset to switch to stand-by after a fixed period. The setting changes to 30minutes, 60 minutes, 90 minutes and 0 minutes (offtimer cancelled) each time the button is pressed.30 MIN 60 MIN0 MIN(Cancel)90 MINWhen three minutes remain, “OFF TIMER 3 MIN”will flash.The off timer is cancelled if a power interruptionoccurs.OFF TIMER 90MIN1234 10:00PC4:3♪ COMPONENTMEMORY NAME: MEMORY2NANODRIFT3D