Panasonic TH-65PF50U Operating Instructions Manual

Also see for TH-60PF50U: Operating instructions

Contents

Panasonic TH-65PF50U Operating Instructions Manual Manual pdf 27 page image

27H-POS Adjust the horizontal position. V-POS Adjust the vertical position.H-SIZE Adjust the horizontal size. V-SIZE Adjust the vertical size.DOTCLOCK(During Component/PC input signal)Periodic striped pattern interference (noise) may occur when a striped pattern is displayed. If this happens,adjust so that any such noise is minimized.CLOCKPHASE(During Component/PC input signal)Eliminate the flickering and distortion.OVERSCANTurn image over scan ON/OFF.Configurable signals are as follows:525i, 525p, 625i, 625p, 750/60p, 750/50p (Component Video, RGB, DVI, SDI, HDMI)ON OFFNotes:• When “OFF” is set, “H-SIZE” and “V-SIZE” cannot be adjusted.• When the “Display size” is set to “On” in the Options menu, this setting will be invalid. (see page 56)Adjusting POS./SIZENotes:• If the dot clock frequency of an analog signal is 162 MHz or higher, “DOT CLOCK” and “CLOCK PHASE”cannot be automatically corrected.• When digital signal input, DOT CLOCK and CLOCK PHASE cannot be made.• AUTO SETUP may not work when a cropped or dark image is input. In such case, switch to a bright imagewith borders and other objects are clearly shown, and then try auto setup again.• Depending on the signal, out of alignment may occur after AUTO SETUP. Carry out fine tuning for theposition/size as required.• If AUTO SETUP cannot set properly for vertical frequency 60Hz XGA signal (1024×768@60Hz,1280×768@60Hz, and 1366×768@60Hz), pre-selecting the individual signal in “XGA MODE” (see page52) may results in correct AUTO SETUP.• AUTO SETUP does not work well when a signal such as additional information is superimposed out ofvalid image period or intervals between synchronizing and image signals are short, or for image signal withtri-level synchronizing signal added.• If AUTO SETUP cannot adjust correctly, select “NORMALIZE” once and press ACTION ( ) then adjustPOS./SIZE manually.