Panasonic TH-58PF12WK Operating Instructions Manual

Contents

Panasonic TH-58PF12WK Operating Instructions Manual Manual pdf 8 page image

SERIALPC INAUDIOSLOT1 SLOT3PR /CR /R P B/C B/B Y/GCOMPONENT/RGB INLANSLOT2AUDIO1 212 12128ConnectionsSpeakerterminal (R)Speakerterminal (L)When connecting the speakers, be sure to use only the optional accessory speakers.Refer to the speaker’s Installation Manual for details on speaker installation.AC cord connection (see page 12)Speakers (Optional accessories)Pass the attached cablexing band through the clipas shown in the gure.To secure cables connected to Terminals, wrap the cable xing band around themthen pass the pointed end through the locking block, as shown in the gure.While ensuring there is sufcient slack in cables to minimize stress (especiallyin the power cord), rmly bind all cables with the supplied xing band.To tighten: To loosen:PullPullPush the catch– AC cord xingNote: At factory shipment, Terminal boards are installed in SLOT 2 and SLOT 3.– Cable xing bandSecure any excess cables with band as required.Note:One xing band is supplied with this unit. In case of securing cables at two positions, please purchase it separately.Note:Make sure that the ACcord is locked on both theleft and right sides.Pushuntilthe hookclicks.2. Pulloff.CloseOpen1 Plug the AC cord into the displayunit.Plug the AC cord until it clicks.2 Fix the AC cord with the clamperwhich is attached to the unit.For the TH-58PF12WK:Clampers are not installed to thisunit. Ensure there is sufcient slackin the AC cord and rmly bind withthe supplied cable xing band, etc.1. Keep theknobpressed.Unplug the AC cordUnplug the ACcord pressingthe two knobs.Note:When disconnecting the AC cord,be absolutely sure to disconnectthe AC cord plug at the socketoutlet rst.From SERIALTerminal onComputer(see page 10)From EXTERNALmonitor terminalon Computer(see page 9)Dual HDMI Terminals(equivalent of DualHDMI Terminal Board(TY-FB10HMD))(see page 11)Optional TerminalBoard Insert Slot(covered)COMPONENT/RGB INTerminals(see page 11)LAN Terminal(see page 57)