Panasonic TH-58PF12WK Operating Instructions Manual

Contents

Panasonic TH-58PF12WK Operating Instructions Manual Manual pdf 48 page image

3D Y/C Filter (NTSC)Colour systemSignalOnAutoCinema realityPanasonic Auto (4 : 3)Off4 : 3[ AV ]Noise reduction OffRefresh Rate 100 HzCinema reality OffyXGA Mode Auto48Setup for Input SignalsColour system / Panasonic AutoSelect Signal from the “Setup” menu during AV(S Video) input signal. (“Signal [AV]” menu is displayed.)Press to select the “Colour system” or “Panasonic Auto”.Press to select each functions.If the picture image becomes unstable:With the system set on Auto, under conditions of low level or noisy input signals the image may in rare casesbecome unstable. Should this occur, set the system to match the format of the input signal.Cinema realityPress to select Cinema reality.Press to set On / Off.Cinema reality:When on, the display attempts to reproduce a more natural interpretation of sources such as movie pictures, whichare recorded at 24 frames per second. If the picture is not stable, turn the setting to off.Note:When On, this setting only affects the following signal input:• NTSC / PAL signal input during “AV (S Video)” input signal.• 525i (480i), 625i (575i), 1125 (1080) / 60i signal input during “Component” input signal.Mode FunctionColour system Set the colour system to match the input signal. When selecting “Auto”, the Colour system is automaticallyselected from NTSC/PAL/SECAM, however, M.NTSC signal is not displayed properly depending onthe attached terminal board. To display M.NTSC signal, select “M.NTSC” in Colour system.To display PAL60 signal, select “PAL” when BNC Dual Video Terminal Board (TY-FB9BD) is used. Forother Video Terminal Boards, select “M.NTSC”.Auto SECAM M.NTSC NTSCPALPanasonic Auto(4 : 3)Set to “4 : 3” to view 4:3 images in an unchanged format when Panasonic Auto is selected.If you would like to view 4:3 images in Just format, set to “Just”.Note:Panasonic Auto does not function when BNC Dual Video Terminal Board (TY-FB9BD) is used.Note:After making this setting, be sure to make each adjustment (such as “Auto Setup”) on the “Pos. /Size” menu asnecessary. (see page 23)XGA ModeThis menu is displayed when the input signal is analog (Component/PC). This unit supports three types of XGA signals with60Hz vertical frequency having different aspect ratios and sampling rates (1,024 × 768 @ 60Hz, 1,280 × 768 @ 60Hz and1,366 × 768 @ 60Hz).Press to select “XGA Mode”.Press to select “Auto”, “1024×768”, “1280×768” , “1366×768”.Auto: Automatically selected from 1024×768/1280×768/1366×768.Switch the setting to suit the input signal for better displaydepends on the angle of view or display resolution condition.